Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Tigers\]\s+Ballast\s+resistor\s+voltage\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[Tigers\]\s+Ballast\s+resistor\s+voltage\s*$/: 6 ]

Total 6 documents matching your query.

1. [Tigers] Ballast resistor voltage (score: 1): Author: <awtiger@cox.net>; Date: Mon, 26 Sep 2011 9:37:47 -0400; How much voltage should get through the ballast resistor going to the points? My multi-meter shows a full 12 volts going in and 10 volts coming out. I was always under the impression that the resist; /html/tigers/2011-09/msg00145.html (7,311 bytes)
2. Re: [Tigers] Ballast resistor voltage (score: 1): Author: "Smit, Theo" <Theo.Smit@dynastream.com>; Date: Mon, 26 Sep 2011 10:15:41 -0500; Hi Andy, It should be about half, but only when the points are closed. When the points are open then you're going to see 12V because there is no current flowing. Cheers, Theo This e-mail and any atta; /html/tigers/2011-09/msg00146.html (9,235 bytes)
3. [Tigers] Ballast resistor voltage (score: 1): Author: Carmods@aol.com; Date: Mon, 26 Sep 2011 11:27:18 -0400 (EDT); Hi Andy, The voltage at the resistor will be lower when the points are closed than when they are open due to the higher current going through it to the coil. * Put a jumper wire from points terminal; /html/tigers/2011-09/msg00147.html (7,020 bytes)
4. Re: [Tigers] Ballast resistor voltage (score: 1): Author: "Thomas Witt" <atwittsend@verizon.net>; Date: Mon, 26 Sep 2011 09:11:26 -0700; The voltage needed (desired) is dependent upon the coil used. So, if your using a stock coil it should be what the factory dictated (sorry, I don't know that voltage). If your using an aftermarket c; /html/tigers/2011-09/msg00148.html (8,590 bytes)
5. Re: [Tigers] Ballast resistor voltage (score: 1): Author: " Ron Fraser" <rfraser@bluefrog.com>; Date: Mon, 26 Sep 2011 12:50:43 -0400; I have always read 9 volts. I see the Shop Manual states 6-7 volts but you have to remember this is the stock coil, points and condenser system. I checked my Tiger and I see a 1 volt drop but my sys; /html/tigers/2011-09/msg00149.html (9,183 bytes)
6. Re: [Tigers] Ballast resistor voltage (score: 1): Author: Tony Somebody <achd73@yahoo.com>; Date: Mon, 26 Sep 2011 11:49:07 -0700 (PDT); Anyone not running a stock setup might want to make sure the syestem they have does or does not make use of the ballast resistor. For example I have an Accell electronic distributor and a few months; /html/tigers/2011-09/msg00151.html (10,232 bytes)

Current List: 1 - 6
Page: [1]