- 1. [Tigers] Exhaust Manifold question (score: 1)
- Author: George Re <mgman71@comcast.net>
- Date: Wed, 22 Jun 2011 14:33:01 +0000 (UTC)
- I am just about to send my manifolds out for coating but have run into a small problem. There are 2 tubes on the Right manifold one goes to the choke and one goes to the bottom of the air cleaner HOW
- /html/tigers/2011-06/msg00096.html (7,084 bytes)
- 2. Re: [Tigers] Exhaust Manifold question (score: 1)
- Author: <e.coiner@cox.net>
- Date: Wed, 22 Jun 2011 11:11:13 -0700
- Its a press fit. Grab with pliers and pull with a gently rotating motion. Most likely they are rusty and will snap off. Then you drill them out and get a replacement kit from any Mustang supplier. __
- /html/tigers/2011-06/msg00098.html (8,095 bytes)
- 3. Re: [Tigers] Exhaust Manifold question (score: 1)
- Author: David or Gary Franchi <wwwdg@webtv.net>
- Date: Thu, 23 Jun 2011 01:58:20 GMT
- Since you have it off, I would heat the area around the tube with a torch, then try and wiggle the tubes loose. David Its a press fit. Grab with pliers and pull with a gently rotating motion. Most li
- /html/tigers/2011-06/msg00101.html (8,766 bytes)
- 4. Re: [Tigers] Exhaust Manifold question (score: 1)
- Author: " Ron Fraser" <rfraser@bluefrog.com>
- Date: Wed, 22 Jun 2011 15:23:15 -0400
- See Tigersunited for a picture of the exhaust manifold and tubes; Section AF, plate D. http://www.tigersunited.com/resources/parts_rs260/FactParts.asp Both tubes should pull out of the manifold but
- /html/tigers/2011-06/msg00173.html (9,264 bytes)
This search system is powered by
Namazu