- 1. [Tigers] Holley Gasket Sealing (score: 1)
- Author: Steve Sage <fastsage@cox.net>
- Date: Fri, 20 Jun 2008 21:47:33 -0700
- Hello Sunbeamers: The Tiger is just about ready for the trip to Tiger's United next week. I am thinking of re-installing my Adjust A Jet plate on my Holley carb. For anyone who doesn't know, you take
- /html/tigers/2008-06/msg00332.html (8,427 bytes)
- 2. Re: [Tigers] Holley Gasket Sealing (score: 1)
- Author: Tony Somebody <achd73@yahoo.com>
- Date: Fri, 20 Jun 2008 22:32:43 -0700 (PDT)
- Dont over torque when tightening AND I would buy an extra set of gaskets to take with- that way you wont need them BUT go witout a spare set and see if you are lucky enough someone else has some. TTT
- /html/tigers/2008-06/msg00333.html (10,122 bytes)
- 3. Re: [Tigers] Holley Gasket Sealing (score: 1)
- Author: "Buck Trippel" <BuckTrippel@Verizon.net>
- Date: Fri, 20 Jun 2008 22:57:19 -0700
- I had the bright idea of running the Holley Adjust A Jets in our SCF race Tiger. It worked fine on the dyno. However, on the track the Adjust A Jet plates caused the engine to stall under hard braki
- /html/tigers/2008-06/msg00334.html (9,128 bytes)
- 4. Re: [Tigers] Holley Gasket Sealing (score: 1)
- Author: Steve Laifman <SLaifman@SoCal.rr.com>
- Date: Sat, 21 Jun 2008 11:31:47 -0700
- Steve Sage, Just a quickie. When I needed a gasket to my 4 BBL Holley 465 CFM LAT carb, (venturi to throttle plate) there were more than one gasket that would "fit". However, many gaskets look alike,
- /html/tigers/2008-06/msg00343.html (8,345 bytes)
- 5. Re: [Tigers] Holley Gasket Sealing (score: 1)
- Author: Steve Sage <fastsage@cox.net>
- Date: Sat, 21 Jun 2008 13:50:18 -0700
- Hello Steve L: You are definitely correct on not all gaskets being alike. That was one of my problems with my last carb take a part. I used an after market gasket "for" Holley carbs. It turns out the
- /html/tigers/2008-06/msg00350.html (9,492 bytes)
This search system is powered by
Namazu