- 1. [oletrucks] 216 questions (score: 1)
- Author: "David Welch" <dwelch@onebox.com>
- Date: Sun, 03 Dec 2000 18:56:13 -0800
- Looks like this might be a bit off topic these days, but I have an engine Does anybody know if it is "safe" to remove the three panhead screws holding on the little plate (and the plate) located just
- /html/oletrucks/2000-12/msg00090.html (7,489 bytes)
- 2. [oletrucks] 216 questions (score: 1)
- Author: "David Welch" <dwelch@onebox.com>
- Date: Sun, 03 Dec 2000 18:56:53 -0800
- Looks like this might be a bit off topic these days, but I have an engine Does anybody know if it is "safe" to remove the three panhead screws holding on the little plate (and the plate) located just
- /html/oletrucks/2000-12/msg00091.html (7,477 bytes)
- 3. RE: [oletrucks] 216 questions (score: 1)
- Author: "Tibbers" <tibbers@earthlink.net>
- Date: Mon, 4 Dec 2000 03:56:36 -0800
- Heli Coils are stainless steel, so shouldn't have any problem. I have used them in every imagineable place on an engine and had great success. Just take your time and make sure the hole and new threa
- /html/oletrucks/2000-12/msg00097.html (8,220 bytes)
- 4. [oletrucks] 216 Questions (score: 1)
- Author: "Mac Kinghorn" <kinghorn@granite.mb.ca>
- Date: Mon, 4 Dec 2000 23:19:02 -0500
- In answer to your question in part the plate with the 3 screws in it is an oil pressure regulator. Behind the plate is a gasket, another plate with the spring loaded regulator in it then a second ga
- /html/oletrucks/2000-12/msg00131.html (7,317 bytes)
This search system is powered by
Namazu