Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[oletrucks\]\s+55\s+2nd\s+$wanna\'be\'rod$\s+update\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[oletrucks\]\s+55\s+2nd\s+$wanna\'be\'rod$\s+update\s*$/: 5 ]

Total 5 documents matching your query.

1. [oletrucks] 55 2nd (wanna'be'rod) update (score: 1): Author: "Border,Ryan" <rborder@fcxena.fc.hp.com>; Date: Tue, 6 Jul 1999 15:48:37 -0600; Well, on the 4th of July, after laying dormant in my garage for several months, my 55 2nd finally rolled again. I finally got the new wiring harness installation completed. There were a few final puz; /html/oletrucks/1999-07/msg00162.html (12,059 bytes)
2. RE: [oletrucks] 55 2nd (wanna'be'rod) update (score: 1): Author: Tom Burt <tburt@hirose.com>; Date: Tue, 6 Jul 1999 15:36:13 -0700; Looks good Ryan! There is finally light at the end of the tunnel. It feels good, doesn't it? I would go monochrome if your looking at high rechroming costs. Pitted or rusty trim would have to be stri; /html/oletrucks/1999-07/msg00167.html (12,553 bytes)
3. Re: [oletrucks] 55 2nd (wanna'be'rod) update (score: 1): Author: "william moldenhauer" <wmh678@worldnet.att.net>; Date: Tue, 6 Jul 1999 19:49:09 -0500; Ryan according to my chiltons the points should be set at .019 dwell @ 28 to 32 degrees hope this helps bill 53-3600 street rod --Original Message-- From: Border,Ryan <rborder@fcxena.fc.hp.com> To: o; /html/oletrucks/1999-07/msg00173.html (13,606 bytes)
4. Re: [oletrucks] 55 2nd (wanna'be'rod) update (score: 1): Author: WR Teto <monadnoc@wgserv.crystal-mtn.com>; Date: Tue, 06 Jul 1999 22:23:02 -0400; Ryan, my Haynes manual for my 72 Chevelle lists the following specs: breaker point gap: .019" dwell angle: 29-31 degrees centrifugal advance: roughly 11-12 degrees @2200 RPM vacuum advance: 0 degree; /html/oletrucks/1999-07/msg00180.html (7,658 bytes)
5. Re: [oletrucks] 55 2nd (wanna'be'rod) update (score: 1): Author: "tcape" <tcape@weblnk.net>; Date: Sun, 11 Jul 1999 13:38:45 -0400; The '55 is looking great, Ryan! Hope the "problems" all turn out to be smaller than you think. Great work so far! Tom Caperton '47 2nd 3100 designed starter doubts ended coil a is makes oletrucks is; /html/oletrucks/1999-07/msg00313.html (13,533 bytes)

Current List: 1 - 5
Page: [1]