- 1. Re: [oletrucks] Corvette Valve Cover mods (score: 1)
- Author: "william moldenhauer" <wmh678@worldnet.att.net>
- Date: Fri, 1 Oct 1999 19:02:26 -0500
- first off the reason you do not have any of these is because the older engines had the oil filler through the intake manifold and the breather was a tube off the rear. the solution is to go to your l
- /html/oletrucks/1999-10/msg00024.html (8,200 bytes)
- 2. [oletrucks] Corvette Valve Cover mods (score: 1)
- Author: Edward Miller <edngael@open.org>
- Date: Fri, 01 Oct 1999 19:29:59 -0700
- Hi Bob, I had a set of valve covers like that one time, and when I tried to put them on my truck the bolt holes wouldn't line up. It's possible I have 350 heads on my motor; last time I had the valve
- /html/oletrucks/1999-10/msg00029.html (8,522 bytes)
- 3. Re: [oletrucks] Corvette Valve Cover mods (score: 1)
- Author: MarkNoakes@aol.com
- Date: Sat, 2 Oct 1999 00:20:02 EDT
- The cast aluminum corvette valve covers were made to fit both the staggered bolt hole pattern on the early V8's and the straight bolt pattern of the later V8's. Many of the Corvette mail order parts
- /html/oletrucks/1999-10/msg00032.html (9,208 bytes)
- 4. [oletrucks] Corvette Valve Cover mods (score: 1)
- Author: rchansle@us.ibm.com
- Date: Thu, 30 Sep 1999 13:45:35 -0600
- I have an old set of Corvette aluminum valve covers that I would like to use on my small block. However, the Corvette covers dont have any holes for the pvc valve or a breather. I was thinking of add
- /html/oletrucks/1999-09/msg00764.html (7,001 bytes)
- 5. Re: [oletrucks] Corvette Valve Cover mods (score: 1)
- Author: "Robert Welch" <rwelch@ionet.net>
- Date: Thu, 30 Sep 1999 15:08:35 -0500
- I was faced with a similar situation with a set of old Edelbrock valve covers. There really is only two solutions. If the block is old enough to have a draft tube, use it w/a pcv valve and let the oi
- /html/oletrucks/1999-09/msg00765.html (9,085 bytes)
This search system is powered by
Namazu