Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[oletrucks\]\s+Ignition\s+Timing\s+Question\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[oletrucks\]\s+Ignition\s+Timing\s+Question\s*$/: 5 ]

Total 5 documents matching your query.

1. [oletrucks] Ignition Timing Question (score: 1): Author: "William Gray" <william.gray@snet.net>; Date: Wed, 16 Jan 2002 16:28:19 -0500; This is my 1st note to this net - I hope I'm doing it right. Does anyone have the ignition timing specs for a pre-computer 350 in a 3/4 or 1 ton truck? I need to know initial, centrugal and vacuum ad; /html/oletrucks/2002-01/msg00298.html (7,389 bytes)
2. Re: [oletrucks] Ignition Timing Question (score: 1): Author: "Claude Ramey" <cramey@earthlink.net>; Date: Wed, 16 Jan 2002 16:19:51 -0600; I put a 350 in my '85 and was concerned about timing advance even working. I found this on the internet and saved it: http://www.dashlink.com/~rameyfam/Timing.htm I put some timing tape on the balanc; /html/oletrucks/2002-01/msg00299.html (8,431 bytes)
3. Re: [oletrucks] Ignition Timing Question (score: 1): Author: "Allen Jones" <jonesal@u.washington.edu>; Date: Wed, 16 Jan 2002 14:52:50 -0800; Yes! You answered your own question. I was battling the timing on my '73 pickup after I installed HEI (350 with Edelbrock products and a stock HEI installed). I pulled the HEI off a camero, slapped i; /html/oletrucks/2002-01/msg00300.html (9,731 bytes)
4. RE: [oletrucks] Ignition Timing Question (score: 1): Author: "William Gray" <william.gray@snet.net>; Date: Thu, 17 Jan 2002 17:20:09 -0500; Thanks to all who responded. Just found a 1967 Chilton's that has distributor specs. For the 283 it says 40 initial, 300 centrifugal at 4100 rpm and 150 vacuum at 15.5" (crank degrees). I guess I'll; /html/oletrucks/2002-01/msg00315.html (9,198 bytes)
5. RE: [oletrucks] Ignition Timing Question (score: 1): Author: "William Gray" <william.gray@snet.net>; Date: Fri, 18 Jan 2002 16:27:09 -0500; Oops - that should be 30 degrees centrifugal at 4100 rpm and 15 degrees Not 300 and 150. I guess I pushed the 0 too long. Bill Gray william.gray@snet.net --Original Message-- From: owner-oletrucks@au; /html/oletrucks/2002-01/msg00334.html (9,697 bytes)

Current List: 1 - 5
Page: [1]