Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[oletrucks\]\s+TF\s+Bed\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[oletrucks\]\s+TF\s+Bed\s*$/: 6 ]

Total 6 documents matching your query.

1. [oletrucks] TF Bed (score: 1): Author: "Doug Wathor" <wathor@comcast.net>; Date: Thu, 28 Aug 2003 07:13:25 -0700; I finally got the clutch head screwdrivers I needed to remove the rear fenders on my '56, and now I'm close to removing the rest of the bed. However, it appears like the bed sides are welded to the m; /html/oletrucks/2003-08/msg00379.html (7,474 bytes)
2. Re: [oletrucks] TF Bed (score: 1): Author: Ryan Sain <rsain@gte.net>; Date: Thu, 28 Aug 2003 08:27:37 -0700; When we pulled apart our bed, there were no welds in those places. Ours simply unbolted. Came apart quite easily. - Ryan 59 3100 Step oletrucks is devoted to Chevy and GM trucks built between 1941 a; /html/oletrucks/2003-08/msg00382.html (7,903 bytes)
3. Re: [oletrucks] TF Bed (score: 1): Author: "bgibson" <bgibson@mcc4u.com>; Date: Thu, 28 Aug 2003 10:53:42 -0700; You are right they are welded, I used a die grinder to unweld them. Question, are your sides bad? I think if I had it to do all over again I would buy a new front panel, install it then sandblast the; /html/oletrucks/2003-08/msg00383.html (8,550 bytes)
4. Re: [oletrucks] TF Bed (score: 1): Author: wayne osborne <wayne@chevytrucks.org>; Date: Thu, 28 Aug 2003 13:17:56 -0400; Mine were spot welded in a few locations along the bed side. --wayne Wayne Osborne http://www.chevytrucks.org http://www.chevytrucks.org/wayne oletrucks is devoted to Chevy and GM trucks built betwee; /html/oletrucks/2003-08/msg00385.html (8,060 bytes)
5. Re: [oletrucks] TF Bed (score: 1): Author: Bruce Kettunen <bekett@uslink.net>; Date: Thu, 28 Aug 2003 14:45:48 -0500; The entire bed should be bolted together only. Only factory welds are the spot welds that hold the angle at the bottom of the sides. A lot can happen to a truck in 47 years. Bruce K 57 3200 Mt. Iron,; /html/oletrucks/2003-08/msg00390.html (8,182 bytes)
6. Re: [oletrucks] TF Bed (score: 1): Author: "bgibson" <bgibson@mcc4u.com>; Date: Thu, 28 Aug 2003 16:34:57 -0700; Bruce, I think he is talking about the Rear Cross Sill Not the bed angle's Just a guess??? HooT58 -- Original Message -- From: "Bruce Kettunen" <bekett@uslink.net> To: <oletrucks@autox.team.net> Sent; /html/oletrucks/2003-08/msg00393.html (9,043 bytes)

Current List: 1 - 6
Page: [1]