Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[oletrucks\]\s+Thread\s+dimensions\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[oletrucks\]\s+Thread\s+dimensions\s*$/: 6 ]

Total 6 documents matching your query.

1. [oletrucks] Thread dimensions (score: 1): Author: "Mark Self" <mark.self@verizon.net>; Date: Thu, 13 Nov 2003 22:43:55 -0800; I'm trying to figure what the thread pitch is on my '55 1st 3100 1/2 ton emergency brake clevis. There is a clevis connected to the bell cranks on both ends of the emergency brake cross shaft. One is; /html/oletrucks/2003-11/msg00190.html (7,686 bytes)
2. Re: [oletrucks] Thread dimensions (score: 1): Author: Ribbit2@aol.com; Date: Fri, 14 Nov 2003 06:26:32 EST; Don't know if this will help or not but 5-16th standard threads are 24 and 18 not 16. There is no help in the Factory assembly manual only part numbers. Good luck. Jim H 57-3100-SB oletrucks is devot; /html/oletrucks/2003-11/msg00191.html (6,968 bytes)
3. Re: [oletrucks] Thread dimensions (score: 1): Author: Ribbit2@aol.com; Date: Fri, 14 Nov 2003 10:22:57 EST; Went outside with a thread gauge that was in my tap and die set and measured my 57 clevis rod and it is 24 tpi. Hope this is the same as yours. this is standard national fine threads. Good luck. Jim; /html/oletrucks/2003-11/msg00192.html (7,069 bytes)
4. Re: [oletrucks] Thread dimensions (score: 1): Author: "Steve Hanberg" <steve@OldSub.com>; Date: Fri, 14 Nov 2003 08:03:42 -0800; I'd stop by the hardware store and buy one of each pitch 5/16ths bolt they had, and then see which would match up the best. I'm trying to figure what the thread pitch is on my '55 1st 3100 1/2 ton em; /html/oletrucks/2003-11/msg00193.html (8,098 bytes)
5. Re: [oletrucks] Thread dimensions (score: 1): Author: Bob Fischer <r.fischerjr@worldnet.att.net>; Date: Fri, 14 Nov 2003 12:17:31 -0800; Hi Mark, I know I said this B4 but you have to be close to get'n that baby goin. Checked the threads on the original 49 rear, still set'n on the back of the 53 COE, and they're 5/16-24. I don't recal; /html/oletrucks/2003-11/msg00194.html (9,142 bytes)
6. Re: [oletrucks] Thread dimensions (score: 1): Author: "K. M. Lehmann" <klehmann@bentonrea.com>; Date: Fri, 14 Nov 2003 16:27:50 -0800; Good Idea Bob, as most people only use parking brake for vehicle inspection. the 53 COE, and they're 5/16-24. as I did and just loop the cables end of the cable would go and clamp it down course, so; /html/oletrucks/2003-11/msg00195.html (9,854 bytes)

Current List: 1 - 6
Page: [1]