- 1. [oletrucks] carb choke screws (score: 1)
- Author: mark@noakes.com
- Date: Mon, 13 Oct 2003 14:13:06 -0700 (PDT)
- I'm working thru my Rochester 2-bbl restoration and had to take the choke plate shaft out. It is held in with 2 small brass screws, staked in place, and of course I damaged one getting it out. I was
- /html/oletrucks/2003-10/msg00115.html (7,623 bytes)
- 2. Re: [oletrucks] carb choke screws (score: 1)
- Author: "K. M. Lehmann" <klehmann@bentonrea.com>
- Date: Mon, 13 Oct 2003 16:47:41 -0700
- Hi Mark I have been using small stainless screws. It's been a while since I bought any, but I believe I found them at Lowes. I also use Locktite instead of upsetting the ends. The other nice thing is
- /html/oletrucks/2003-10/msg00117.html (8,515 bytes)
- 3. Re: [oletrucks] carb choke screws (score: 1)
- Author: Mask1966@aol.com
- Date: Mon, 13 Oct 2003 19:46:20 EDT
- Mark, What kind of Rochester? Is it a 2GC? If so, I have a spare and can probably live without two screws. I would think loctite would work fine. A small center punch will stake the screw too. Mike K
- /html/oletrucks/2003-10/msg00118.html (7,382 bytes)
- 4. Re: [oletrucks] carb choke screws (score: 1)
- Author: mark@noakes.com
- Date: Mon, 13 Oct 2003 18:06:20 -0700 (PDT)
- thanks; I'll try this approach first and than go back to raid someone's spares doesn't work. I'm still surprised that none of the auto parts places had them. mark noakes oletrucks is devoted to Chevy
- /html/oletrucks/2003-10/msg00120.html (8,990 bytes)
- 5. Re: [oletrucks] carb choke screws (score: 1)
- Author: "Gary Perry" <glperry@fwi.com>
- Date: Tue, 14 Oct 2003 11:38:19 -0500
- Mark, a couple years ago I was driving my 54 two-ton with a car trailer on it. Cruising about 40ish. Went to let up on throttle, and nothing happened, still cruising! Got pulled over shutting off eng
- /html/oletrucks/2003-10/msg00134.html (9,598 bytes)
This search system is powered by
Namazu