Those who did the 1500 SU carb conversion, did you reuse your US spec 1500 exhaust manifold, or did you use something else? TIA -=Chris Chris King - cbking@alum.rpi.edu http://members.home.net/kvcbk
Hello Chris, exhaust manifold, or did you use something else? Reused the stock exhaust manifold, converted to manual choke, and got a new throttle cable. -- Best regards, Bill mailto:w.gilroy@verizon
Getting ready to, but haven't done it. I was planning on using the same gasket, can't see a reason not to. Well a new one, anyway ;-) Larry At this exact moment in time 1/17/02 8:56 AM, "Chris King"
Date: Thu, 17 Jan 2002 18:38:15 +0000 (US/Eastern)
[demime could not interpret encoding binary - treating as plain text] I'm using a PaceSetter header. I bought it when the original cast iron manifold cracked and a header was less expensive than a re
4-2-1 header. Standard gaskets. Lotsa mashing. The EGR valve was in the way of the new intake manifold. Mike Chris Kotting spec 1500 exhaust manifold, or did you use something else? /// unsubscribe/c
Ooops I appear to have answered a question that hadn't been asked. I also have a header on mine. And just installed a 2" exhaust all the way to the back, including a glasspack muffler. Boy howdy does
Chris King - cbking@alum.rpi.edu My stock manifold has the EGR valve on top - I was afraid it might be in the way... -=Chris /// unsubscribe/change address requests to majordomo@autox.team.net or try
Hello Chris, the way... I removed mine and plugged the hole with a plug and some furnace cement. -- Best regards, Bill mailto:w.gilroy@verizon.net /// unsubscribe/change address requests to majordomo
4-2-1 header. Standard gaskets. Lot's of mashing. /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.team.net/mailman/listinfo /// Archives at http://www.team.n
I don't know--I am using the Pacesetter manifold as well, but have not mounted the manifold yet. --David C. /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.t
Sorry it took so long to respond. I used the original manifold with the EGR removed and hole plugged. Original pipe for the header pipe but necked it up to a 2.25. The muffler is a glass pack followe
I have a comment/question. When I was installing my exhaust system with a glasspack bullet muffler, we got into a discussion about pipe sizes. I went from the stock 1 1/2" up to 1 3/4", but in the di
Hello Dan, Just an FYI, I used the stock exhaust system all the out the rear. -- Best regards, Bill mailto:w.gilroy@verizon.net /// unsubscribe/change address requests to majordomo@autox.team.net or