Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*2000\s+clutch\s+recommendations\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*2000\s+clutch\s+recommendations\s*$/: 6 ]

Total 6 documents matching your query.

1. 2000 clutch recommendations (score: 1): Author: "Andrew Jacobs" <Legal-Z@worldnet.att.net>; Date: Fri, 14 May 1999 19:16:36 -0400; just looking for some suggestions on a good source for a quality clutch at (if possible) a reasonable price. also, while i'm at it, just how hard is an engine removal?? i've done a 240z and it was re; /html/datsun-roadsters/1999-05/msg00414.html (7,137 bytes)
2. Re: 2000 clutch recommendations (score: 1): Author: Fred_Katz@ci.sf.ca.us; Date: Fri, 14 May 1999 17:03:08 -0700; Mike Kerr of Roadster Restorations is where I got my clutch. He will also offer lots of tips. Phone: (530) 644-6777, Fax: (530) 644-7252 Engine removal is relatively easy, and only takes a few hours; /html/datsun-roadsters/1999-05/msg00417.html (8,097 bytes)
3. Re: 2000 clutch recommendations (score: 1): Author: Xcokid@aol.com; Date: Sat, 15 May 1999 19:12:38 EDT; Whoa, if remember correctly, if you don't drain the transmission and you pull the splined shaft out of the rear of the five speed, you'll get a dose of oil out of rear of the transmission when you ti; /html/datsun-roadsters/1999-05/msg00429.html (7,190 bytes)
4. Re: 2000 clutch recommendations (score: 1): Author: "Fred Katz" <fredkatz@2xtreme.net>; Date: Sat, 15 May 1999 23:54:48 -0700; No, you've got it backwards. When you pull the driveshaft (with the spline) from the rear of the 5-speed, there is no oil there! That's because there is a short 8-inch section with a U-joint bolted t; /html/datsun-roadsters/1999-05/msg00433.html (8,359 bytes)
5. Re: 2000 clutch recommendations (score: 1): Author: DemonTSi@aol.com; Date: Sun, 16 May 1999 04:57:34 EDT; << It's the 1600 with 4-speed that will spill oil, unless you wrap the trans tailshaft, or drain the oil from the trans. The last time I pulled my 1600 and 4-speed, I wrapped the tailshaft. Everythin; /html/datsun-roadsters/1999-05/msg00434.html (7,587 bytes)
6. Re: 2000 clutch recommendations (score: 1): Author: Ron Hamilton <ej99176@goodnet.com>; Date: Sun, 16 May 1999 06:50:41 -0700; Or find an old driveshaft and remove the needed piece and just slide it into place and wire it on until you are done. That is what I have done. Ron; /html/datsun-roadsters/1999-05/msg00435.html (7,847 bytes)

Current List: 1 - 6
Page: [1]