I've done this a couple of times by poking one end of the (cut) grommet into position then rotating it about the hose as if it were threaded on the outside. Only had to 'encourage' with a blunt instr
<< I decided that I had to cut them to fit them over the hoses and just rubber, I've done this a couple of times by poking one end of the (cut) grommet into position then rotating it about the hose a
struggling with getting them fitted into the shroud holes while the hoses are through...grrrr.... .... into position then rotating it about the hose as if it were threaded on the outside. >< You shou
Well, I'm back from my grueling matrimony stint in Macon... For the last few weeks, I've had the B's cooling system apart and generally been sprucing up a lot of stuff in the engine bay. I hope "Pun