Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*A\s+thought\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*A\s+thought\s*$/: 3 ]

Total 3 documents matching your query.

1. A thought (score: 1): Author: Bob Chamberlain <bobchamb@southwind.net>; Date: Wed, 12 May 1999 02:27:24; I was looking at some old wire wheels I had and noticed that some had small, half-moon indentations on the brake side of the hub. At first, I thought these were some kind of tooling mark, but the clo; /html/spridgets/1999-05/msg00679.html (7,349 bytes)
2. Re: A thought (score: 1): Author: "Angela Hervey-Tennyson & Peter Westcott" <toobmany@bigpond.com>; Date: Wed, 12 May 1999 21:17:26 +1000; Absolutely correct. The wheel should be 100% home against the taper. I fell for this about nineteen years ago. If you're not sure about clearance put a dob of plasticene on the end of each stud and r; /html/spridgets/1999-05/msg00681.html (7,952 bytes)
3. Re: A thought (score: 1): Author: "Larry Miller" <millerls@ado13.com>; Date: Wed, 12 May 1999 06:57:08 -0700; It's possible. When I converted to wires I cut the studs so the wire would fit. Easier than changing them. me,--when; /html/spridgets/1999-05/msg00688.html (8,175 bytes)

Current List: 1 - 3
Page: [1]