Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Addendum\s+to\s+Nikasil\s+coated\s+bores\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Addendum\s+to\s+Nikasil\s+coated\s+bores\s*$/: 3 ]

Total 3 documents matching your query.

1. Addendum to Nikasil coated bores (score: 1): Author: John Goodman <ggl205@yahoo.com>; Date: Sun, 4 May 2003 05:40:20 -0700 (PDT); One or two motorcycle racers inquired about honing coated cylinder bores. I responded by saying that the procedure was very much like honing cast iron. Although the honing process is very similar to; /html/land-speed/2003-05/msg00096.html (7,882 bytes)
2. RE: Addendum to Nikasil coated bores (score: 1): Author: "Albaugh, Neil" <albaugh_neil@ti.com>; Date: Fri, 9 May 2003 14:03:45 -0500; I've always wondered about using electroless nickel plating on cylinder walls. It is easy to apply, it is a low-friction coating, and it heat-treats to a high hardness, so wear should be minimal. Ha; /html/land-speed/2003-05/msg00237.html (8,658 bytes)
3. RE: Addendum to Nikasil coated bores (score: 1): Author: John Goodman <ggl205@yahoo.com>; Date: Fri, 9 May 2003 12:15:44 -0700 (PDT); Most of these coatings are applied at high heat and sometimes referred to as plasma spray. Conversations with various suppliers of this process are quick to point out how proprietary the application; /html/land-speed/2003-05/msg00238.html (9,938 bytes)

Current List: 1 - 3
Page: [1]