Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Axle\s+shafts\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Axle\s+shafts\s*$/: 6 ]

Total 6 documents matching your query.

1. axle shafts (score: 1): Author: BCAH@aol.com; Date: Wed, 27 Oct 1999 22:12:04 EDT; I built up my Bugeye from parts and at the beginning was wondering about the solid wheel vs wire wheel axle situation. My research told me that you could put a wire wheel shaft into the solid wheel h; /html/spridgets/1999-10/msg01803.html (7,337 bytes)
2. Re: axle shafts (score: 1): Author: Bkitterer@aol.com; Date: Thu, 28 Oct 1999 02:17:00 EDT; I am confused here. All of the axle shafts that I have ever seen for disk wheels have a flange on the end which I was sure was forged with the axle. That is they are one piece. Axles for wire wheels; /html/spridgets/1999-10/msg01809.html (8,295 bytes)
3. Re: axle shafts (score: 1): Author: Paul A Asgeirsson <pasgeirsson@juno.com>; Date: Thu, 28 Oct 1999 15:06:16 EDT; Into the fray! All steel wheel axles that FIT a Spridget do not have the same part numbers. The later axles had greter strength to handle the increased HP. They may well have varied slightly in lengt; /html/spridgets/1999-10/msg01837.html (10,279 bytes)
4. Axle shafts (score: 1): Author: bobchamb@southwind.net; Date: Sat, 19 Sep 1998 01:29:44 -0500 (CDT); I believe the axle shafts and the wire wheel hub are a press fit together. If I buy a new axle, what kind of force is needed to separate the two? Can this operation be carried out more than once with; /html/spridgets/1998-09/msg00664.html (6,787 bytes)
5. Re: Axle shafts (score: 1): Author: "Mike Gigante" <mikeg@vicnet.net.au>; Date: Sun, 20 Sep 1998 21:29:05 -0700; They are not press fit. After undoing the knock-on ears (or the octagonal chrome nut), you can rock the wheel off by hand. To remove the half shaft, you need to remove the brake drum (4 nuts) and und; /html/spridgets/1998-09/msg00693.html (7,525 bytes)
6. Re: Axle shafts (score: 1): Author: Rick/Carolyn <walters@mail.softcom.net>; Date: Mon, 21 Sep 1998 20:02:07 +0000; Hi Bob, Yes the Axle shafts are press fit to the hub. The force isn't great, I believe it was only a couple hundred pounds of force to seperate. You could probally drive them off with a punch and a v; /html/spridgets/1998-09/msg00781.html (7,984 bytes)

Current List: 1 - 6
Page: [1]