- 1. Bad TIG bubbles (score: 1)
- Author: "atrav" <atrav@copper.net>
- Date: Sun, 4 Feb 2007 21:19:03 -0500
- I had a weird TIG problem today. I wanted to weld two brackets to a frame, both brackets were identical, steel frame, mild steel brackets. Both brackets got two weld beads each, about four inches apa
- /html/land-speed/2007-02/msg00025.html (7,568 bytes)
- 2. RE: Bad TIG bubbles (score: 1)
- Author: <ddahlgren@snet.net>
- Date: Sun, 4 Feb 2007 21:28:31 -0500
- Why try to weld over all the mess?? I always thought when things go bad before trying anything else get back to uncontaminated.. BTW Miller, Lincoln and Hobart have some great websites and message bo
- /html/land-speed/2007-02/msg00026.html (7,987 bytes)
- 3. Re: Bad TIG bubbles (score: 1)
- Author: Skip Higginbotham <saltrat@pahrump.com>
- Date: Sun, 04 Feb 2007 21:09:53 -0800
- I have run into the same problem. Turned out to be bad steel. There were occlusions in the steel itself. Once I ground out the occlusions it welded just fine. I find this problem in Mexican steel qu
- /html/land-speed/2007-02/msg00027.html (6,347 bytes)
- 4. Re: Bad TIG bubbles (score: 1)
- Author: Joe Timney <joetimney@dol.net>
- Date: Mon, 05 Feb 2007 09:38:17 -0500
- My best guess is a piece of steel with a high carbon spot. This is not uncommon today with cheap off-shore material. The same thing can happen when using non-DOM tubing ( electric resistance welded)
- /html/land-speed/2007-02/msg00029.html (7,229 bytes)
- 5. RE: Bad TIG bubbles (score: 1)
- Author: "Neil Albaugh" <neil@dbelltech.com>
- Date: Mon, 5 Feb 2007 14:19:36 -0700
- Did you run out of shielding gas? Regards, Neil Tucson, AZ I had a weird TIG problem today. I wanted to weld two brackets to a frame, both brackets were identical, steel frame, mild steel brackets.
- /html/land-speed/2007-02/msg00031.html (8,323 bytes)
- 6. RE: Bad TIG bubbles (score: 1)
- Author: john.szalay@att.net (John Szalay)
- Date: Mon, 05 Feb 2007 22:31:28 +0000
- -- Original message from "Neil Albaugh" <neil@dbelltech.com>: Or perhaps have the flow rate too high, and the torch angled ? close to 90 degrees is best. bad steel is the most probable cause, but a t
- /html/land-speed/2007-02/msg00032.html (7,213 bytes)
- 7. Re: Bad TIG bubbles (score: 1)
- Author: "Doug Anderson" <boogiewoogie12@hotmail.com>
- Date: Tue, 06 Feb 2007 03:17:29 +0000
- Hey! you stole my answer Joe! LOL! VG definition Joey... hey, how you anyway? cheers, "Dirt Track Doug" in So. New Yawk, -- Aron, My best guess is a piece of steel with a high carbon spot. This is no
- /html/land-speed/2007-02/msg00035.html (8,600 bytes)
This search system is powered by
Namazu