- 1. Blown head gasket (score: 1)
- Author: "Ted Schroeder" <tedseven@torchlake.com>
- Date: Fri, 29 Dec 2006 12:13:56 -0500
- About two years ago I had some head work done on my BN-1. I replaced the head using a new gasket. I coated the gasket on both sides with silver spray paint before installation. This fall the gasket
- /html/healeys/2006-12/msg00345.html (6,826 bytes)
- 2. Re: Blown head gasket (score: 1)
- Author: Dave & M <rusd@velocitus.net>
- Date: Fri, 29 Dec 2006 12:01:37 -0700
- Hi Ted, There is no "easy" and permanent solution. Retorquing is only a stop gap to correct something that is in the process of failing. The BN1, BN2 head stud layout is not real good. You need to ha
- /html/healeys/2006-12/msg00352.html (9,051 bytes)
- 3. Re: Blown head gasket (score: 1)
- Author: Dave & M <rusd@velocitus.net>
- Date: Fri, 29 Dec 2006 13:55:21 -0700
- Hi Ted, When you say that the surfaces "seem" to be flat, are you absolutely sure that a straight edge laid at right angles to the head & across the cylinder to cylinder joint surfaces will not pass
- /html/healeys/2006-12/msg00358.html (8,740 bytes)
- 4. Blown head gasket (score: 1)
- Author: "Ted Schroeder" <tedseven@torchlake.com>
- Date: Sat, 30 Dec 2006 13:16:39 -0500
- Thanks to Dave Russel, Dave Porter and Paul for all your help. I contacted Gasket Works copper@headgasket.com. They make the stainless .004" rings. They said that the rings may not work with a standa
- /html/healeys/2006-12/msg00386.html (7,087 bytes)
- 5. Re: Blown head gasket (score: 1)
- Author: Dave & M <rusd@velocitus.net>
- Date: Sat, 30 Dec 2006 12:05:55 -0700
- Hi Ted, I have no idea if the suggested combination will work. Solid copper is not very forgiving. Would suggest that you ask "Gasket Works" about needed cylinder head & block "level requirements & s
- /html/healeys/2006-12/msg00388.html (8,407 bytes)
This search system is powered by
Namazu