- 1. Bottom end engine rebuild (score: 1)
- Author: Unknown
- Date: Fri, 27 Jan 2006 09:28:15 -0700
- Well, I have all the parts back and am ready to assemble the bottom end, but I have some questions! (go figure) - I need to check the clearance for the crank to bearings, rings gaps, crank to thrust
- /html/spridgets/2006-01/msg01071.html (7,116 bytes)
- 2. Re: Bottom end engine rebuild (score: 1)
- Author: Unknown
- Date: Fri, 27 Jan 2006 10:05:48 -0800
- Hi Cyrill, Yes, you'll have to undo any bearing cap that you've put a piece of Plasti-gage in. Then you measure the width of the crush with the plast-gage wrapper to see what the clearance is. Then r
- /html/spridgets/2006-01/msg01072.html (8,597 bytes)
This search system is powered by
Namazu