Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Center\s+roll\-over\s+not\s+correct\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Center\s+roll\-over\s+not\s+correct\s*$/: 7 ]

Total 7 documents matching your query.

1. Center roll-over not correct (score: 1): Author: itswonderful@attbi.com; Date: Fri, 07 Feb 2003 19:42:05 +0000; A couple of days ago I described the method I called something like the "symmetrical center roll over method" for selecting push rod length for best valve train geometry. Well, even though this meth; /html/tigers/2003-02/msg00065.html (8,196 bytes)
2. RE: Center roll-over not correct (score: 1): Author: "Palmer, Robert L." <RPalmer@brobeck.com>; Date: Fri, 7 Feb 2003 12:32:02 -0800; It seems to me that changing push rod length can satisfy one or the other criterion, but not both at the same time; either you get maximum extension at half lift (the 90 degree angle point), or you; /html/tigers/2003-02/msg00066.html (9,655 bytes)
3. Re: Center roll-over not correct (score: 1): Author: itswonderful@attbi.com; Date: Fri, 07 Feb 2003 22:30:05 +0000; I should clarify that I think it is possible to get the contact patch symmetrical with this approach but half lift will not occur when the tip is at the centerline of the stem but rather somewhere pa; /html/tigers/2003-02/msg00068.html (7,380 bytes)
4. RE: Center roll-over not correct (score: 1): Author: itswonderful@attbi.com; Date: Fri, 07 Feb 2003 22:35:48 +0000; This part bothers me. Wouldn't the movement be highest and equal at lowest lifts and again at highest lifts? Your working on equal parts of the arc on both sides of 90 degrees in this method. Frank; /html/tigers/2003-02/msg00069.html (7,310 bytes)
5. Re: Center roll-over not correct (score: 1): Author: Craig Wright <cwright@pdghightower.com>; Date: Fri, 07 Feb 2003 14:43:53 -0800; Here is what Comp Cams says about it, although I like Bob's thinking http://compcams.com/information/Products/Pushrods/ Craig; /html/tigers/2003-02/msg00070.html (9,786 bytes)
6. Re: Center roll-over not correct (score: 1): Author: itswonderful@attbi.com; Date: Fri, 07 Feb 2003 22:50:27 +0000; Yes, Comp Cams is who I was refering to as my push rod vendor. That is the method I used which I now believe to be incorrect. the second method I described and that Bob posted a description of seems; /html/tigers/2003-02/msg00072.html (10,346 bytes)
7. Re: Center roll-over not correct (score: 1): Author: Veeseeoso@aol.com; Date: Sat, 8 Feb 2003 08:51:28 EST; Hello Listers, I use roller rockers manufactured by Precision Valve Systems as recommended by the guy who set up my heads. They are a true mid lift or net ratio at zero lash design. The top of the ro; /html/tigers/2003-02/msg00076.html (7,371 bytes)

Current List: 1 - 7
Page: [1]