Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Centering\s+timing\s+chain\s+cover\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Centering\s+timing\s+chain\s+cover\s*$/: 4 ]

Total 4 documents matching your query.

1. Centering timing chain cover (score: 1): Author: Unknown; Date: Tue, 26 Nov 2002 12:57:22 -0800; Thanks for this very basic and yet so essential piece of "wrenching" advice. I have NEVER thought to center the timing chain cover! No wonder mine always leak around the seal! --JohnD == Hi Eddie, A; /html/spridgets/2002-11/msg00961.html (7,609 bytes)
2. Re: Centering timing chain cover (score: 1): Author: Unknown; Date: Tue, 26 Nov 2002 12:42:57 -0800; I've used Paul's kit to restore the rear main seal, used the below described technique to center the timing cover, and the result is that the bottom of my sprite is DRY. I park in the driveway of a f; /html/spridgets/2002-11/msg00965.html (8,554 bytes)
3. Re: Centering timing chain cover (score: 1): Author: Unknown; Date: Tue, 26 Nov 2002 15:53:03 -0800; Hi Glen, If you have the right gasket set, you normally will never need to trim the cork gasket ends. They should stick up about 3/8" on each side before fitting up the pan gasket. The groove in the; /html/spridgets/2002-11/msg00971.html (8,741 bytes)
4. Re: Centering timing chain cover (score: 1): Author: Unknown; Date: Tue, 26 Nov 2002 22:49:58 -0500 5.0; U); I find that I have been using this centering procedure for years before I knew was a procedure. I must have learned the technique from somewhere. Perhaps most of what I've always owned and worked on; /html/spridgets/2002-11/msg00988.html (8,334 bytes)

Current List: 1 - 4
Page: [1]