- 1. Clutch slave cylinder parts (score: 1)
- Author: "Howard Battan" <battanhr@comcast.net>
- Date: Thu, 15 Apr 2004 15:53:45 -0700
- Hi all. In the process of renovating my '57 MGA 1500(mostly), I want to rebuild the clutch slave cylinder. When I disassembled my cylinder I found one part missing from those shown in the MGA Service
- /html/mgs/2004-04/msg00275.html (7,379 bytes)
- 2. RE: Clutch slave cylinder parts (score: 1)
- Author: "Lew Palmer" <lpalmer@roundaboutmanor.com>
- Date: Thu, 15 Apr 2004 19:25:26 -0500
- No one will ever know it's wrong or missing, but there are a couple of 1) Take a wrap of wire around the boot and twist the ends together. 2) Find an appropriately sized steel ring at a hardware stor
- /html/mgs/2004-04/msg00277.html (8,130 bytes)
- 3. Re: Clutch slave cylinder parts (score: 1)
- Author: Barney Gaylord <barneymg@MGAguru.com>
- Date: Thu, 15 Apr 2004 21:02:12 -0500
- Not exactly leakproof. If the piston seal leaks, the outer boot will never retain the fluid. But the small ring on the boot can help to keep dirt and water out of the cylinder, and therefore delay or
- /html/mgs/2004-04/msg00279.html (9,020 bytes)
- 4. RE: Clutch slave cylinder parts (score: 1)
- Author: "Howard Battan" <battanhr@comcast.net>
- Date: Thu, 15 Apr 2004 19:29:29 -0700
- Thanks Lew and Barney for the info on the small boot clip in the clutch slave cylinder. I'll be able to fashion a clip based on your ideas. Howard Battan
- /html/mgs/2004-04/msg00280.html (7,024 bytes)
- 5. Re: Clutch slave cylinder parts (score: 1)
- Author: Bob Howard <mgbob@juno.com>
- Date: Fri, 16 Apr 2004 08:50:03 -0400
- Would a nylon cable-tie do the job? That's what Moss supplies for tie-rod boots and MB for its axle boot kits. Bob On Thu, 15 Apr 2004 15:53:45 -0700 "Howard Battan" <battanhr@comcast.net> writes:
- /html/mgs/2004-04/msg00284.html (7,258 bytes)
- 6. Re: Clutch slave cylinder parts (score: 1)
- Author: "Frank Krajewski" <frankk@intap.net>
- Date: Fri, 16 Apr 2004 15:12:28 -0400
- Howard: I use an appropriatelt siezed tie wrap and clip any excess when I cannot locate the ring you are describing. Frank "Swamp Yankee" Krajewski -- Original Message -- From: "Howard Battan" <batta
- /html/mgs/2004-04/msg00298.html (7,995 bytes)
This search system is powered by
Namazu