Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Cryogenics\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Cryogenics\s*$/: 6 ]

Total 6 documents matching your query.

1. Cryogenics (score: 1): Author: Rick Byrnes <Rick@rbmotorsports.com>; Date: Sat, 14 Dec 2002 12:31:14 -0500; I have no scientific data that it works but did use cryo on the latest tall deck 2.3Litre block I used for the N/A motor. The virgin block was shipped to OKC and went thru a process of -300 to +300 t; /html/land-speed/2002-12/msg00499.html (8,090 bytes)
2. Re: Cryogenics (score: 1): Author: Dave Dahlgren <ddahlgren@snet.net>; Date: Sat, 14 Dec 2002 13:55:43 -0500; The real success or failure of the investment will be on the first rebuild. If the cylinders are still very round and the line bore good and no cracks then a good investment. If not money for nothing; /html/land-speed/2002-12/msg00503.html (9,659 bytes)
3. RE: Cryogenics (score: 1): Author: "Albaugh, Neil" <albaugh_neil@ti.com>; Date: Mon, 16 Dec 2002 10:18:14 -0600; You might try aluminum "tooling plate"-- it is made specifically for maintaining dimensional stability after machining. It is a special grade of stress-relieved cast aluminum plate. Regards, Neil Tu; /html/land-speed/2002-12/msg00569.html (8,678 bytes)
4. Re: Cryogenics (score: 1): Author: "Jim Dincau" <jdincau@qnet.com>; Date: Mon, 16 Dec 2002 09:15:05 -0800; Hi all, The "tooling plate" we used at the old lazy L was dimensionally stable but the alloy was an unknown. We suspected it was cast from remelted chips as we once found a carbide tool bit imbedded; /html/land-speed/2002-12/msg00572.html (7,203 bytes)
5. Re: Cryogenics (score: 1): Author: Dave Dahlgren <ddahlgren@snet.net>; Date: Mon, 16 Dec 2002 12:50:03 -0500; I looked into it but does not have the physical properties that I needed.. been using 2024 T4 Dave /// unsubscribe/change address requests to majordomo@autox.team.net or try /// http://www.team.net/m; /html/land-speed/2002-12/msg00574.html (7,345 bytes)
6. RE: Cryogenics (score: 1): Author: "Albaugh, Neil" <albaugh_neil@ti.com>; Date: Mon, 16 Dec 2002 12:00:24 -0600; Yes, if strength is a requirement, tooling plate is not a good choice! I'll bet there is a difference in locked-in stress in wrought aluminum plate depending on whether you machine with the grain or; /html/land-speed/2002-12/msg00575.html (8,146 bytes)

Current List: 1 - 6
Page: [1]