- 1. Dizzy drive dog pin (score: 1)
- Author: "Phil Nase" <nase@ptd.net>
- Date: Sun, 4 Jun 2006 12:55:05 -0400
- Any tips on, how to, or not to, drive the pin back in the drive dog end of the dizzy shaft. I have the pin in the freezer now but I'm hoping there is a quicker method. I'm re using the pin since its
- /html/spridgets/2006-06/msg00091.html (6,940 bytes)
- 2. Re: Dizzy drive dog pin (score: 1)
- Author: Frank Clarici <spritenut@comcast.net>
- Date: Sun, 04 Jun 2006 13:16:46 -0400
- Phil The shaft is drilled for a one way only pin fitment. If you try it 180 out, you can do it but now you bent the pin. Stick the drive on and look thru the hole, make sure it is on the right way. I
- /html/spridgets/2006-06/msg00093.html (7,080 bytes)
- 3. Re: Dizzy drive dog pin (score: 1)
- Author: "Peter C." <nosimport@mailbag.com>
- Date: Sun, 04 Jun 2006 12:36:11 -0500
- Vise..... no tapping needed. It isn't that tight. Be sure you line the dog offset up properly with the notch for the rotor on the upper shaft. Often the pins will go one way, as the will have been pe
- /html/spridgets/2006-06/msg00094.html (7,201 bytes)
- 4. Re: Dizzy drive dog pin (score: 1)
- Author: "Paul Asgeirsson" <pasgeirsson@worldnet.att.net>
- Date: Sun, 4 Jun 2006 10:37:14 -0700
- Bevel the end a tiny bit. But make sure the drive dog is on the shaft correctly, not 180 degrees off. Sometimes it will go that way! Imagine that! It's also nice to have a solid backing for the drive
- /html/spridgets/2006-06/msg00096.html (7,546 bytes)
- 5. RE: Dizzy drive dog pin (score: 1)
- Author: "Phil Nase" <nase@ptd.net>
- Date: Sun, 4 Jun 2006 14:47:09 -0400
- Thanks you guys. I must be lucky today because I got it in tapping it on the vise anvil and didn't bend the pin. It looks good and no slop. Why are the shaft bushes $70? I'm glad I didn't need one. N
- /html/spridgets/2006-06/msg00099.html (7,586 bytes)
This search system is powered by
Namazu