Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Drill\s+a\s+hole\s+in\s+round\s+tubing\?\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Drill\s+a\s+hole\s+in\s+round\s+tubing\?\s*$/: 6 ]

Total 6 documents matching your query.

1. Drill a hole in round tubing? (score: 1): Author: David Cole <dgcole01@bellsouth.net>; Date: Mon, 24 Feb 2003 10:19:00 -0600; What is the best way to drill a hole in round tubing? I need to drill a 1/4" hole through a section of 1.25" chrome moly tubing on the chassis of my race car. What is the best way to insure the hole; /html/shop-talk/2003-02/msg00047.html (7,679 bytes)
2. Re: Drill a hole in round tubing? (score: 1): Author: "Peter J. Thomas" <pjthomas@adelphia.net>; Date: Mon, 24 Feb 2003 11:57:58 -0500; You need a guide that you can make yourself. Take a block of wood and using a drill press, bore a 1.25" hole. Perpendicular, bore the 1/4" hole through the block. If you can, slide this guide over th; /html/shop-talk/2003-02/msg00048.html (8,214 bytes)
3. Re: Drill a hole in round tubing? (score: 1): Author: Derek <dereklola@yahoo.com>; Date: Mon, 24 Feb 2003 09:44:18 -0800 (PST); You say the hole has wallowed out over the years. Was there no tube welded into the original holes to take the pin? If not I strongly suggest you simply drill the current hole oversize, say 3/8", and; /html/shop-talk/2003-02/msg00049.html (8,187 bytes)
4. Re: Drill a hole in round tubing? (score: 1): Author: "Jim & Nadia Higgins" <seamus@iwaynet.net>; Date: Mon, 24 Feb 2003 13:18:00 -0500; Could you enlarge the wallowed out hole, insert and weld a bushing in this hole and insert your pin through the bushing? This would be a stronger set up than just a hole and less likely to fail a se; /html/shop-talk/2003-02/msg00052.html (7,832 bytes)
5. Re: Drill a hole in round tubing? (score: 1): Author: "Elton Clark" <lotus.tony@airmail.net>; Date: Mon, 24 Feb 2003 14:32:03 -0600; I'm pretty sure Carroll Smith, author of "Engineering to Win" and 5 or 6 other race car builder books, would have said the exact same thing. Tony in Texas /// unsubscribe/change address requests to m; /html/shop-talk/2003-02/msg00056.html (7,735 bytes)
6. RE: Drill a hole in round tubing? (score: 1): Author: <Tim.Mullen@trw.com>; Date: Mon, 24 Feb 2003 16:33:59 -0500; Also consider that just drilling a hole thru the frame tubes will create a weaker spot on the tubing (and a possible point for cracks to start). Welding in the tube thru the hole will greatly increas; /html/shop-talk/2003-02/msg00057.html (7,813 bytes)

Current List: 1 - 6
Page: [1]