- 1. English terminology (score: 1)
- Author: Glen <grbyrns@ucdavis.edu>
- Date: Sat, 09 Oct 1999 23:49:54 -0700
- Looking through my "Austin Healey Sprite MkI" shop manual(no, there was no publishing date anywhere in the book to explain the 'MkI') shop manual, I enjoyed all the little language differences, but t
- /html/spridgets/1999-10/msg00764.html (7,561 bytes)
- 2. Re: English terminology (score: 1)
- Author: Herb_Goede@amsinc.com
- Date: Tue, 12 Oct 1999 16:51:50 -0600
- You do understand that they are talking about body working with lead, don't you? Superior to Bondo but much more expensive, heavier and harder to use. I recently stripped a '79 RX7 for painting. To
- /html/spridgets/1999-10/msg00765.html (7,323 bytes)
- 3. English terminology (score: 1)
- Author: Glen <grbyrns@ucdavis.edu>
- Date: Sun, 10 Oct 1999 00:57:44 -0700
- Yes, I know it refers to leading of the sheet metal. I've not seen any brazing on any car I've worked on, but I don't get out much. Brazing puts a lot more heat on the thin sheet metal than leading.
- /html/spridgets/1999-10/msg00771.html (7,253 bytes)
- 4. Re: English terminology (score: 1)
- Author: Bkitterer@aol.com
- Date: Wed, 13 Oct 1999 03:36:48 EDT
- << You do understand that they are talking about body working with lead, don't you? Superior to Bondo but much more expensive, heavier and harder to use. I recently stripped a '79 RX7 for painting. T
- /html/spridgets/1999-10/msg00800.html (7,331 bytes)
- 5. Re: English terminology (score: 1)
- Author: Gerard Chateauvieux <pixelsmith@gerardsgarage.com>
- Date: Wed, 13 Oct 1999 01:28:40 -0700
- Sure, you need to get the metal glowing red to braze, lead melts at a much lower temperature. Just the small areas I've tackled caused a lot of distortion. Gerard G G Gerard Chateauvieux E A R R pixe
- /html/spridgets/1999-10/msg00805.html (8,403 bytes)
This search system is powered by
Namazu