Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Figure\s+it\s+out\!\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Figure\s+it\s+out\!\s*$/: 6 ]

Total 6 documents matching your query.

1. Re: Figure it out! (score: 1): Author: Unknown; Date: Tue, 20 Jul 2004 12:00:55 +0200; John, It should be possible with a good pair of scissors .....and a lot of patience . Cheers Mike http://mikek.9online.fr/index.htm updated July 16 2004; /html/triumphs/2004-07/msg00433.html (6,586 bytes)
2. Re: Figure it out! (score: 1): Author: Unknown; Date: Tue, 20 Jul 2004 06:12:29 -0500; I was off the list last week and missed the thread, but maybe these comments will be of help. I make brass shim gaskets for the bottom of the liners all the time. I buy it by the six inch by six foot; /html/triumphs/2004-07/msg00434.html (7,992 bytes)
3. Re: Figure it out! (score: 1): Author: Unknown; Date: Tue, 20 Jul 2004 10:31:25 -0400; You can start a hole in shim stock using a Dremel tool with an abrasive cutoff disc. It cuts easily without raising any stress or distortion in the shim stock. BTDT to make .010 steel shims for the t; /html/triumphs/2004-07/msg00435.html (9,247 bytes)
4. Re: Figure it out! (score: 1): Author: "Mike Kitchener" <mikek@9online.fr>; Date: Tue, 20 Jul 2004 12:00:55 +0200; John, It should be possible with a good pair of scissors .....and a lot of patience . Cheers Mike http://mikek.9online.fr/index.htm updated July 16 2004; /html/triumphs/2004-07/msg01263.html (7,045 bytes)
5. Re: Figure it out! (score: 1): Author: "Jack W. Drews" <vinttr4@geneseo.net>; Date: Tue, 20 Jul 2004 06:12:29 -0500; I was off the list last week and missed the thread, but maybe these comments will be of help. I make brass shim gaskets for the bottom of the liners all the time. I buy it by the six inch by six foot; /html/triumphs/2004-07/msg01264.html (8,545 bytes)
6. Re: Figure it out! (score: 1): Author: Peter Fullam <pfullam@nycap.rr.com>; Date: Tue, 20 Jul 2004 10:31:25 -0400; You can start a hole in shim stock using a Dremel tool with an abrasive cutoff disc. It cuts easily without raising any stress or distortion in the shim stock. BTDT to make .010 steel shims for the t; /html/triumphs/2004-07/msg01265.html (9,788 bytes)

Current List: 1 - 6
Page: [1]