- 1. Float Valve Stickies (score: 1)
- Author: "Ed E. Powell" <102430.3640@compuserve.com>
- Date: 29 Jan 97 12:17:21 EST
- Mine is stuck in the "UP" position. Hey, hey, hey -- this IS about Tigers. I'm referring to float valve in my carburetor (gosh, you can't be too careful, can you?). The carburetor is original -- I co
- /html/tigers/1997-01/msg00324.html (7,439 bytes)
- 2. Re: Float Valve Stickies (score: 1)
- Author: nicholsj@oakwood.org
- Date: Wed, 29 Jan 97 13:44:23 EST
- For replacement carbs Holley makes two 2bl carbs, one is 350cfm and the other is 500cfm. The 350cfm is a one for one swap but the 500cfm will make you remove the spacer plate or enlarge the throttle
- /html/tigers/1997-01/msg00325.html (8,629 bytes)
- 3. Re[2]: Float Valve Stickies (score: 1)
- Author: LeBrun@hii.hitachi.com
- Date: Wed, 29 Jan 97 11:38:53 PST
- Anyone run an Edelbrock TORKER on a TIGER? In order to equalize the intake runners, the carb sits at about a 20-25 degree offset from being perfectly lined up with the centerline of the engine. Takes
- /html/tigers/1997-01/msg00327.html (9,357 bytes)
- 4. RE: Float Valve Stickies (score: 1)
- Author: Bill Cartus <Bill.Cartus@bridge.bst.bls.com>
- Date: Wed, 29 Jan 1997 13:46:58 -0600
- Welcome back to discussing Tigers. You will get the basic answer of replaceing the "needle & seat with a kit ($7-10 is a guess). If stock, take the littel aluminum 'tag' with a number on it and get
- /html/tigers/1997-01/msg00330.html (8,117 bytes)
- 5. RE: Float Valve Stickies (score: 1)
- Author: "Ed E. Powell" <102430.3640@CompuServe.COM>
- Date: 30 Jan 97 22:08:28 EST
- Thanks to all for the input on this. I'll probably try the rebuild first, confining my effort to the float valve works only. If I grow weary of repeated rebuilds, I can go with a new unit later. I ag
- /html/tigers/1997-01/msg00345.html (7,251 bytes)
This search system is powered by
Namazu