- 1. Front Wheel Bearings Thrust Face (score: 1)
- Author: "Mark Endicott" <mark@nashvilletn.org>
- Date: Wed, 24 May 2006 10:44:41 -0500
- I am reassembling the front hubs on my Bugeye and need a confidence check on the bearing placement. As I recall from doing it 10 years ago the "Thrust" marking on the bearings are like this: The "Thr
- /html/spridgets/2006-05/msg00809.html (7,334 bytes)
- 2. Re: Front Wheel Bearings Thrust Face (score: 1)
- Author: "Paul Asgeirsson" <pasgeirsson@worldnet.att.net>
- Date: Wed, 24 May 2006 09:14:42 -0700
- NOT RIGHT!!!! The thrust surfaces should be facing each other. Said another way, on each individual wheel, the thrust sides should be towards the center of the hub. Paul A on "Thrust" to
- /html/spridgets/2006-05/msg00810.html (7,944 bytes)
- 3. Re: Front Wheel Bearings Thrust Face (score: 1)
- Author: "Peter C." <nosimport@mailbag.com>
- Date: Wed, 24 May 2006 11:19:19 -0500
- The Moss Motors catalog does a good job on this. It takes a little spatial figuring to make the leap from their diagram, but there are several brands of bearing whose writing may be on the thrust, o
- /html/spridgets/2006-05/msg00811.html (7,826 bytes)
- 4. RE: Front Wheel Bearings Thrust Face (score: 1)
- Author: "Duncan Sinclair" <duncan@pondhop.com>
- Date: Wed, 24 May 2006 11:32:55 -0500
- In the Haynes manual is states that some bearings are marked thrust on the inner race and some on the outer race, so this would reverse the markings. Is this a valid point Paul? Do bearings come both
- /html/spridgets/2006-05/msg00813.html (7,524 bytes)
- 5. Re: Front Wheel Bearings Thrust Face (score: 1)
- Author: "Mark Endicott" <mark@nashvilletn.org>
- Date: Wed, 24 May 2006 11:56:16 -0500
- THANKS Paul and Peter, It is a bit confusing! "Front Wheel Bearings Front wheel bearings are thrust bearings: if installed backwards, the hubs may come loose from the axels. Bearings marked "thrust"
- /html/spridgets/2006-05/msg00814.html (9,214 bytes)
This search system is powered by
Namazu