- 1. HS2 Float Level and RB Accelerator Pedal (score: 1)
- Author: Unknown
- Date: Mon, 07 Oct 2002 15:34:22 +0000
- Good morning Listerati! Saturday I finally got around to pulling the tops off of the float chambers of the HS2 carbs on my 74 Midget. It has had an unhappy tendancy of starving out in lefthanded u-tu
- /html/spridgets/2002-10/msg00176.html (8,039 bytes)
- 2. Re: HS2 Float Level and RB Accelerator Pedal (score: 1)
- Author: Unknown
- Date: Mon, 07 Oct 2002 18:31:10 -0400
- Thin washers under the needle valve. -- Frank Clarici Toms River, NJ 2 Sprites, 2 Midgets http://www.exit109.com/~spritenut /// unsubscribe/change address requests to majordomo@autox.team.net or try
- /html/spridgets/2002-10/msg00188.html (7,796 bytes)
- 3. Re: HS2 Float Level and RB Accelerator Pedal (score: 1)
- Author: Unknown
- Date: Mon, 7 Oct 2002 19:32:56 -0500
- But wouldn't shims lower the effective fuel level in the bowl? My problem was that the level was already too low, the inverted assembly had the float too far away from the lid. I haven't pulled the
- /html/spridgets/2002-10/msg00194.html (8,405 bytes)
- 4. Re: HS2 Float Level and RB Accelerator Pedal (score: 1)
- Author: Unknown
- Date: Mon, 07 Oct 2002 20:38:18 -0400
- David I am so used to having the plastic floats leak from the overflow, I didn't even think about the "too low" fuel level. You don't have gross jets do you? Those round ball float valves? They may b
- /html/spridgets/2002-10/msg00195.html (8,056 bytes)
- 5. Re: HS2 Float Level and RB Accelerator Pedal (score: 1)
- Author: Unknown
- Date: Mon, 7 Oct 2002 20:00:20 -0500
- No, I don't have the GroseJets. Haynes says that the gap should be 1/8" to 3/16", but mine were just over 1/4"! I put the floats into the carb tops that I swiped the older floats from and they were
- /html/spridgets/2002-10/msg00196.html (8,150 bytes)
This search system is powered by
Namazu