- 1. Nuts was Re: Torque wrench recommendations (score: 1)
- Author: Unknown
- Date: Mon, 16 Oct 2000 15:05:54 EDT
- I am sure there is a simple way to calculate a revised torque figure when switching from one grade of bolt to another. There is nothing special about the manufacturers figures - they just decided to
- /html/spridgets/2000-10/msg00791.html (7,676 bytes)
- 2. Re: Nuts was Re: Torque wrench recommendations (score: 1)
- Author: Unknown
- Date: Mon, 16 Oct 2000 16:33:22 -0500
- Ok, if it's so simple, why don't you come up with it. We could all use it. You must not be an engineer. There's a lot more involved in deciding which grade and type of fastener to use than calculatin
- /html/spridgets/2000-10/msg00816.html (8,534 bytes)
- 3. Re: Nuts was Re: Torque wrench recommendations (score: 1)
- Author: Unknown
- Date: Tue, 17 Oct 2000 14:32:11 EDT
- Well, it is simple because as another lister pointed out there are tables and stuff that 'engineers' have already produced. So there is a lot more involved in deciding which grade and type of fastene
- /html/spridgets/2000-10/msg00938.html (7,507 bytes)
- 4. Fw: Nuts was Re: Torque wrench recommendations (score: 1)
- Author: Unknown
- Date: Tue, 17 Oct 2000 15:13:11 -0400
- I guess it would make a lot of difference if you put the grade 5 fastener on a Chippendale table it wouldn't be as strong as if you put it on an Oak Express table. The strength of table would determi
- /html/spridgets/2000-10/msg00947.html (8,209 bytes)
This search system is powered by
Namazu