Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*O\.T\.\.\.\.Welding\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*O\.T\.\.\.\.Welding\s*$/: 6 ]

Total 6 documents matching your query.

1. O.T....Welding (score: 1): Author: Dan and Louise Yates <yates@sk.sympatico.ca>; Date: Wed, 03 Oct 2001 16:21:13 -0600; I was rebuilding the clutch linkage on my work truck today (rebuilding the rod ends and turning slots back into round holes) and I started to wonder if a welded part that is cherry red will wear long; /html/datsun-roadsters/2001-10/msg00112.html (7,076 bytes)
2. Re: O.T....Welding (score: 1): Author: Gary McCormick <svgkm@halley.ca.essd.northgrum.com>; Date: Wed, 03 Oct 2001 15:51:31 -0700; Leaving the part to air cool slowly will generally result in lower hardness. It upon the alloy composition, temperature and cooling rate. Mild carbon steel doesn't get /real/ hard when quenched, but; /html/datsun-roadsters/2001-10/msg00113.html (7,880 bytes)
3. Re: O.T....Welding (score: 1): Author: Fred Schroeder <roadster@texoma.net>; Date: Wed, 03 Oct 2001 19:07:53 -0500; I would consider this carefully. The temperature of the steel when it is quenched is quite critical as well as the carbon content. If it is too hot it will become brittle (and it doesn't take much!); /html/datsun-roadsters/2001-10/msg00116.html (8,019 bytes)
4. Re: O.T....Welding (score: 1): Author: Thomas Walter <twalter@austin.rr.com>; Date: Wed, 03 Oct 2001 19:25:57 -0500; Depends on what the linkage is made out of. Most likely it is a low carbon steel. Not heat treatable. You could "case harden" the steel a little. One "old timers trick" is to carbonize the steel. Ta; /html/datsun-roadsters/2001-10/msg00117.html (8,490 bytes)
5. Re: O.T....Welding (score: 1): Author: snyler <marc@animalfirm.com>; Date: Wed, 3 Oct 2001 20:38:45 -0500; I'd heard about this trick for annealing aluminum for shaping...funny how different metals behave...differently. -Marc T. == Marc Tyler Sisterdale TX 1970 1600 #SPL311-31016 "The Jaundiced Kid II" 19; /html/datsun-roadsters/2001-10/msg00120.html (7,607 bytes)
6. Re: O.T....Welding (score: 1): Author: Gary <gkmcc@netgate.net>; Date: Wed, 03 Oct 2001 23:41:41 -0700; Low-carbon mild steel won't get very hard, or very brittle, now matter how quickly it is quenched. The three main factors to consider when heat-treating ferrous alloys are 1) alloy composition - how; /html/datsun-roadsters/2001-10/msg00131.html (9,273 bytes)

Current List: 1 - 6
Page: [1]