- 1. Oil Pressure / Bearings (score: 1)
- Author: Unknown
- Date: Sat, 7 Sep 2002 17:48:46 -0700 (PDT)
- Report, and questions OK, most of you recall my oil pressur problems on Bobbie MG. I ordered and recieved a new spring (wrong one) and ball to replace the pressure relief valve. I used the old spring
- /html/spridgets/2002-09/msg00394.html (7,666 bytes)
- 2. Re: Oil Pressure / Bearings (score: 1)
- Author: Unknown
- Date: Sat, 07 Sep 2002 22:09:05 -0400
- No. But do drain the oil and let it sit with the plug out overnight. I recently replaced rod bearings on a sprite by just dropping the pan and the biggest hassle was the oil dripping on my face. Righ
- /html/spridgets/2002-09/msg00396.html (7,472 bytes)
- 3. Re: Oil Pressure / Bearings (score: 1)
- Author: Unknown
- Date: Sat, 07 Sep 2002 22:22:22 -0400
- Absolutely!! Frank changed two and I changed two........... We let it drain for about 15 minutes and there was plenty of oil left to foul up a couple of pairs of safty glasses. If you drain the oil j
- /html/spridgets/2002-09/msg00399.html (8,034 bytes)
- 4. Re: Oil Pressure / Bearings (score: 1)
- Author: Unknown
- Date: Sat, 07 Sep 2002 23:44:42 -0400
- Lon, I'm in mid rod bearing replacement right now. The Bugeye is easy, there's nothing under or near the oil pan to prevent removal, not so sure on your car. No need to pull the head. Once the pan wa
- /html/spridgets/2002-09/msg00400.html (8,914 bytes)
- 5. Re: Oil Pressure / Bearings (score: 1)
- Author: Unknown
- Date: Sat, 07 Sep 2002 19:39:52 -0700
- Normally the rod bearings will not produce that kind of oilpressure situation. It is the mains and/or the pump assembly that will do that to you. If a rod (s) bearing were that bad, it would be knock
- /html/spridgets/2002-09/msg00401.html (7,608 bytes)
This search system is powered by
Namazu