Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Oil\s+Pump\s+Caution\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Oil\s+Pump\s+Caution\s*$/: 8 ]

Total 8 documents matching your query.

1. Oil Pump Caution (score: 1): Author: "Fred Pixley" <fpixley@kingston.net>; Date: Tue, 19 Jan 1999 09:17:44 -0500; I've reassembled the Marina and have it running again. The rebuild was done in the car and consisted of new rings, rod bearings and three of the main bearings. The two end mains are not accessible wi; /html/mgs/1999-01/msg01074.html (7,854 bytes)
2. Re: Oil Pump Caution (score: 1): Author: Trevor Boicey <tboicey@brit.ca>; Date: Tue, 19 Jan 1999 19:25:48 -0500; Suggest to turn the car over, plugs out, until pressure occurs. The load on the big ends is much lower without compression and power, so they don't suffer so much until pressure gets up. Filling the; /html/mgs/1999-01/msg01102.html (7,534 bytes)
3. Re: Oil Pump Caution (score: 1): Author: "Neil Cotty" <neilc@tradesrv.com.au>; Date: Wed, 20 Jan 1999 11:44:30 +1000; Can you explain that a bit more for me? Do you mean actually filling it with jelly, and restarting the car with it in place? How does that make the pressure go up faster, because it constricts the o; /html/mgs/1999-01/msg01105.html (7,333 bytes)
4. Re: Oil Pump Caution (score: 1): Author: Gaetke <gaetke@ix.netcom.com>; Date: Wed, 20 Jan 1999 19:52:51 -0800; I'm just finishing my rebuild, and I planned to pour oil into the engine where the hose attaches that goes to the oil cooler (or I guess right to the filter if an oil cooler isn't installed) once it'; /html/mgs/1999-01/msg01106.html (7,301 bytes)
5. Re: Oil Pump Caution (score: 1): Author: Susan and John Roper <vscjohn@iamerica.net>; Date: Tue, 19 Jan 1999 21:16:14 -0600; Neil, its a good way to get the pump to pull enough vacuum to prime. John; /html/mgs/1999-01/msg01120.html (7,512 bytes)
6. Re: Oil Pump Caution (score: 1): Author: xyzabcde@earthlink.net; Date: Tue, 19 Jan 1999 19:57:43 +0000; Hi all, Keep in mind that there are two different oil pump gaskets and modern gasket sets come with both. Make sure you're using the correct one by holding it up to both the block and the pump and ve; /html/mgs/1999-01/msg01126.html (7,034 bytes)
7. Re: Oil Pump Caution (score: 1): Author: "Fred Pixley" <fpixley@kingston.net>; Date: Wed, 20 Jan 1999 07:30:28 -0500; My mistake was letting the oil drain from the oil pump while it was off the engine. If you simply fill it until oil runs out of the pump and then reinstall you should get almost instant oil pressure; /html/mgs/1999-01/msg01150.html (7,983 bytes)
8. RE: Oil Pump Caution (score: 1): Author: "Dodd, Kelvin" <doddk@mossmotors.com>; Date: Wed, 20 Jan 1999 07:58:47 -0800; Been there, done that. Pulled an all nighter pulling the motor and replacing the gasket. Felt dumb, thanks for reminding me. Kelvin.; /html/mgs/1999-01/msg01159.html (7,665 bytes)

Current List: 1 - 8
Page: [1]