- 1. PA windscreen measurement (score: 1)
- Author: DB35PA@aol.com
- Date: Tue, 24 Jan 2006 15:12:24 EST
- Hello all, Because of copious amounts of rot, I had to chop out and replace both sides of the scuttle in the area of the mounting holes for windscreen upright supports. Failing to think ahead, I did
- /html/mg-mmm/2006-01/msg00033.html (7,868 bytes)
- 2. Re: PA windscreen measurement (score: 1)
- Author: Jerry Felper <felperg@earthlink.net>
- Date: Tue, 24 Jan 2006 12:27:16 -0800
- Hello all, Because of copious amounts of rot, I had to chop out and replace both sides of the scuttle in the area of the mounting holes for windscreen upright supports. Failing to think ahead, I did
- /html/mg-mmm/2006-01/msg00034.html (9,514 bytes)
- 3. Re: PA windscreen measurement (score: 1)
- Author: "Safety Fast" <mgtom@zoominternet.net>
- Date: Thu, 26 Jan 2006 16:59:17 -0500
- I have 5 P scuttles to check for holes and I'll check them & give you the average. Also, align the bottom flat edge of the chrome windscreen scuttle bracket parallel with the horizontal edge of the
- /html/mg-mmm/2006-01/msg00036.html (9,468 bytes)
- 4. Re: PA windscreen measurement (score: 1)
- Author: "Mike Hughes" <hughes.c.m@worldnet.att.net>
- Date: Thu, 26 Jan 2006 18:17:11 -0500
- Remember to allow for the rubber trim at the bottom of the windscreen, not just at rest but also when folding it! - Mike Hughes -t?t -- Original Message -- From: "Safety Fast" <mgtom@zoominternet.net
- /html/mg-mmm/2006-01/msg00037.html (10,556 bytes)
- 5. RE: PA windscreen measurement (score: 1)
- Author: "Gill.Morbey" <gd.morbey@virgin.net>
- Date: Fri, 27 Jan 2006 21:49:01 -0000
- Also don't make the mistake I did, by mounting the windscreen a tad too far to the rear of the scuttle, as this makes it virtually impossible to fit aero screens to the top of the scuttle with the wi
- /html/mg-mmm/2006-01/msg00038.html (12,058 bytes)
This search system is powered by
Namazu