- 1. Pinion oil seal for tube type axle (score: 1)
- Author: "Gordie's Garage" <mg_garage@comcast.net>
- Date: Fri, 31 Mar 2006 06:12:18 -0500
- Thanks for the tips and links. I've replaced it and put @ 100mi on it so far with not problems. No way I could budge the nut with a 1/2" breaker bar. Just couldn't keep the pinion from rotating. I en
- /html/mgs/2006-03/msg00211.html (7,019 bytes)
- 2. Re: Pinion oil seal for tube type axle (score: 1)
- Author: "Paul Hunt" <paul.hunt1@blueyonder.co.uk>
- Date: Fri, 31 Mar 2006 15:46:00 +0100
- Well, it pre-loads the pinion bearing. So if it were over-crushed I'd expect either pinion bearing noise immediately (which is perhaps more likely with an under-loaded pinion bearing allowing too muc
- /html/mgs/2006-03/msg00212.html (7,302 bytes)
- 3. RE: Pinion oil seal for tube type axle (score: 1)
- Author: "Gordie's Garage" <mg_garage@comcast.net>
- Date: Fri, 31 Mar 2006 19:31:22 -0500
- Yep, I'm with you, JFDI! No funny noises, at least not from the rear end, no pun intended;^) Thanks again. Gordie
- /html/mgs/2006-03/msg00213.html (7,062 bytes)
This search system is powered by
Namazu