Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Priming\s+Oil\s+Pump\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Priming\s+Oil\s+Pump\s*$/: 6 ]

Total 6 documents matching your query.

1. Priming oil pump (score: 1): Author: Mitchel Seff <ms6453@optonline.net>; Date: Fri, 23 May 2003 18:56:39 -0400; I am getting ready to fire up a new rebuild & I'm priming the oil pump with a drill. The most I can muster at about 800rpm is about 19 lbs of pressure @ the gauge. Oil has only dribbled out of the f; /html/6pack/2003-05/msg00494.html (6,646 bytes)
2. Priming Oil Pump (score: 1): Author: "Cary Henry" <caryhenry@hotmail.com>; Date: Mon, 17 Jul 2006 15:14:53 -0400; I just received my GP2 cam from Richard Good, and in the installation instructions it says to drive the oil pump with an electric drill to prime the oiling system prior to start up. I remember seeing; /html/6pack/2006-07/msg00209.html (6,822 bytes)
3. RE: Priming Oil Pump (score: 1): Author: "Navarrette, Vance" <vance.navarrette@intel.com>; Date: Mon, 17 Jul 2006 13:28:15 -0700; The ghetto engineering alternative is what I used; pull the plugs and spin the starter until the oil pressure registers on the oil gauge. It took about 10 seconds, but seemed more like 100. This onl; /html/6pack/2006-07/msg00214.html (7,530 bytes)
4. Re: Priming Oil Pump (score: 1): Author: Greg Perry <rgperry@earthlink.net>; Date: Mon, 17 Jul 2006 15:52:28 -0500 (GMT-05:00); I pack the oil pump with lubriplate 105. This creates a suction that pulls the oil into and primes the oil pump upon startup. It also lubricates the bearing sufaces as it passes through the oil syst; /html/6pack/2006-07/msg00215.html (6,881 bytes)
5. Re: Priming Oil Pump (score: 1): Author: RICK ORTHEN <peketzu@verizon.net>; Date: Mon, 17 Jul 2006 14:03:48 -0700 (PDT); First, remove the distributor drive dog and grind the end of similar diameter bar stock to match the notch on the end of the dog. Chuck the bar in your drill and mate with the oil pump drive. Squeez; /html/6pack/2006-07/msg00217.html (6,880 bytes)
6. Re: Priming Oil Pump (score: 1): Author: Btp44@aol.com; Date: Mon, 17 Jul 2006 23:52:10 EDT; Cary-I made my oil pump driver from a 10" length of 1/2" rod (preferably drill rod because it must not be over .500") and cut a 3/16" wide x 1/4" deep slot using a cutoff wheel and die grinder. If yo; /html/6pack/2006-07/msg00226.html (6,785 bytes)

Current List: 1 - 6
Page: [1]