- 1. Probable Cause (score: 1)
- Author: Frank Clarici <spritenut@Exit109.com>
- Date: Sun, 25 Jan 1998 19:19:20 -0500
- For those following my dilema with the severe oil leak and an almost daily engine pull, I think I may have found the cause. Out of balance flywheel, I always prime my flywheels and write down that p
- /html/spridgets/1998-01/msg00784.html (8,231 bytes)
- 2. Re: Probable Cause (score: 1)
- Author: "Ron Soave" <redlotus@spacey.net>
- Date: Sun, 25 Jan 1998 20:13:07 -0500
- I'd bet that hteory is correct. This happened to me on a Lotus (aluminum flywheel - warps if the sun shines at the wrong angle) - ended up trashing the thrust washers on the crankshaft. The resultin
- /html/spridgets/1998-01/msg00785.html (9,209 bytes)
- 3. Re: Probable Cause (score: 1)
- Author: Eric Mumford <mumford@rpi.edu>
- Date: Mon, 26 Jan 1998 19:27:35 -0500
- Wow - I primed and painted my flywheel too, but I haven't assembled the engine block yet (should get it Thursday or so). Could little bits of paint flaking off from velicity/temperature extremes real
- /html/spridgets/1998-01/msg00804.html (8,185 bytes)
- 4. Re: Probable Cause (score: 1)
- Author: Billy Zoom <billyzoom@earthlink.net>
- Date: Tue, 27 Jan 1998 09:16:41 +0000
- Even the clutch surface??
- /html/spridgets/1998-01/msg00817.html (7,726 bytes)
- 5. Re: Probable Cause (score: 1)
- Author: Frank Clarici <spritenut@Exit109.com>
- Date: Tue, 27 Jan 1998 17:46:23 -0500
- DUHHHHH!!!! NO. I block sanded the paint off the clutch area. Well my old Sprite is all better, no more leak, runs like a top almost. Just have to redo the dizzy drive, I missed by a tooth (I hope) o
- /html/spridgets/1998-01/msg00819.html (9,272 bytes)
- 6. Re: Probable Cause (score: 1)
- Author: Eric Mumford <mumford@rpi.edu>
- Date: Tue, 27 Jan 1998 12:17:43 -0500
- except that of course. e -- ___ __.o,\____ * Eric Mumford * ('v') -> BA-KUK! /__ \ / _ ) * mumford@rpi.edu * (( )) (+)`--(+) * http://travolta.stu.rpi.edu * --"--"--o
- /html/spridgets/1998-01/msg00822.html (8,114 bytes)
- 7. Re: Probable Cause (score: 1)
- Author: Lancer7676 <Lancer7676@aol.com>
- Date: Wed, 28 Jan 1998 06:28:29 EST
- My flywheel is sitting there -- clean but surface rust. I AM going to get it surfaced, but should I do anything like this (paint) to protect it? I was thinking of spraying it with something like Exte
- /html/spridgets/1998-01/msg00825.html (7,814 bytes)
This search system is powered by
Namazu