- 1. Rear Axle Oil Change - Dumb Question #1 (score: 1)
- Author: MGTD1952@cs.com
- Date: Sun, 15 Jun 2003 13:42:13 EDT
- Okay, I'm ready to change the oil in my rear axle (68 BGT) for the first time, and I can't figure what tool to remove the drain plu or full/level plug with. To large for a 3/8" drive, too small for a
- /html/mgs/2003-06/msg00419.html (7,216 bytes)
- 2. RE: Rear Axle Oil Change - Dumb Question #1 (score: 1)
- Author: "Larry Hoy" <list@marketvalue.net>
- Date: Sun, 15 Jun 2003 13:14:38 -0600
- First make sure all the gunk is out of the hole (very important) then your 1/2" square drive will fit most of the way in. Since this is the first time you may find the thing is really tight. I rememb
- /html/mgs/2003-06/msg00424.html (8,218 bytes)
- 3. Re: Rear Axle Oil Change - Dumb Question #1 (score: 1)
- Author: MGTD1952@cs.com
- Date: Sun, 15 Jun 2003 18:00:32 EDT
- Looks like I'm off to grind down the 1/2" drive (as soon as I can find that old one, it's around here somewhere....) Steve in NJ /// or try http://www.team.net/cgi-bin/majorcool /// Archives at http:
- /html/mgs/2003-06/msg00430.html (7,608 bytes)
- 4. Re: Rear Axle Oil Change - Dumb Question #1 (score: 1)
- Author: "Dean T. Lake" <dtlake@erols.com>
- Date: Mon, 16 Jun 2003 08:33:11 -0400
- --Original Message-- Okay, I'm ready to change the oil in my rear axle (68 BGT) for the first time, and I can't figure what tool to remove the drain plug or full/level plug with. To large for a 3/8"
- /html/mgs/2003-06/msg00445.html (7,827 bytes)
- 5. Re: Rear Axle Oil Change - Dumb Question #1 (score: 1)
- Author: Jon Asdourian <kriegerii@yahoo.com>
- Date: Mon, 16 Jun 2003 06:04:07 -0700 (PDT)
- I am buying a lift for my garage, due to the loose of my other storage, can anyone tell me the heigth of a 69 MGCGT, I am at work, and trying to figure out What lift will work with my limited space,
- /html/mgs/2003-06/msg00446.html (7,713 bytes)
- 6. RE: Rear Axle Oil Change - Dumb Question #1 (score: 1)
- Author: "Scott & Lynn Hower" <howersl@att.net>
- Date: Mon, 16 Jun 2003 21:41:38 -0400
- first Hi Steve, I use this: http://home.att.net/~howersl/mg/mgbolt.jpg The bolt head is 13/16in. The 4 sides are ground at a slight taper to the bolt shank. Sort of like a cone, but with 4 straight
- /html/mgs/2003-06/msg00468.html (8,051 bytes)
This search system is powered by
Namazu