Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Replacing\s+clutch\s+on\s+BJ7\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Replacing\s+clutch\s+on\s+BJ7\s*$/: 6 ]

Total 6 documents matching your query.

1. Replacing clutch on BJ7 (score: 1): Author: ahy3000@comcast.net; Date: Mon, 21 Aug 2006 14:14:51 +0000; I'm attempting to build up my courage and replace my clutch this Fall. I want to confirm that I can pull this after removing the trans tunnel and prop shaft WITHOUT pulling the engine. I saw a threa; /html/healeys/2006-08/msg00511.html (6,566 bytes)
2. RE: Replacing clutch on BJ7 (score: 1): Author: "Freese, Ken" <Kendall.Freese@Aerojet.com>; Date: Mon, 21 Aug 2006 09:11:32 -0700; I have done it in a day. Yes, you need some floor jacks. A strong helper is strongly encouraged also. While you are in there, replace the clutch hose. While you are in there, do the throttle cross s; /html/healeys/2006-08/msg00514.html (7,352 bytes)
3. Re: Replacing clutch on BJ7 (score: 1): Author: David Nock <healeydoc@sbcglobal.net>; Date: Mon, 21 Aug 2006 10:12:48 -0700; Some of the other things that you should do while installing a new Transmission seals front and rear Shifter seal on top shift trans Rear crank seal kit on all 6 cylinder cars New slave cylinder and; /html/healeys/2006-08/msg00517.html (7,985 bytes)
4. Re: Replacing clutch on BJ7 (score: 1): Author: "Rich C" <richchrysler@quickclic.net>; Date: Mon, 21 Aug 2006 21:53:00 -0400; The engine must be supported at the back end while the gearbox is being removed. I usually use a small scissors jack with a piece of plywood to support the engine. It helps everything to remove and; /html/healeys/2006-08/msg00539.html (10,002 bytes)
5. Re: Replacing clutch on BJ7 (score: 1): Author: "Bluechipracing" <bluechipracing@snet.net>; Date: Tue, 22 Aug 2006 08:33:44 -0400; WRT the dowel bolts, I always understood they are at 1 and 7 o'clock when viewed while sitting in the cockpit facing forward. Am I wrong on this? Jim "> Important note: Two of the bell housing bolts; /html/healeys/2006-08/msg00553.html (7,556 bytes)
6. Re: Replacing clutch on BJ7 (score: 1): Author: "Mark and Kathy" <mgtrcars@galaxyinternet.net>; Date: Tue, 22 Aug 2006 21:08:17 -0400; Mine went in at about 11 and 5 sitting in the cockpit. Mark; /html/healeys/2006-08/msg00581.html (8,139 bytes)

Current List: 1 - 6
Page: [1]