- 1. Reversing Lamp Switch (score: 1)
- Author: Philip Hubbard <phubbard@carroll.com>
- Date: Sun, 24 May 1998 20:28:21 -0400
- Well, I went back in to check on this and got to a point where I thought I'd better ask a question. Reading from Haynes I realized that I am supposed to peel carpet and sound proofing back from the t
- /html/spridgets/1998-05/msg00419.html (7,882 bytes)
- 2. Re: Reversing Lamp Switch (score: 1)
- Author: "Steve Byers" <byers@cconnect.net>
- Date: Sun, 24 May 1998 20:48:06 -0400
- The reversing switch is mounted on the passenger's side of the gearbox, just at the base, and forward of, the shifter, You should be able to see it by removing the shifter boot, but I'm not sure how
- /html/spridgets/1998-05/msg00421.html (9,040 bytes)
- 3. Re: Reversing Lamp Switch (score: 1)
- Author: "Peter Samaroo" <mrbugeye@hotmail.com>
- Date: Mon, 25 May 1998 03:54:49 PDT
- The instructions in the Haynes might be for a 1500 midget. For a 1275 you just need to remove the shift boot assembly then the reverse switch is on the passenger side just in front of the gear shift
- /html/spridgets/1998-05/msg00429.html (8,553 bytes)
- 4. Reversing Lamp Switch (score: 1)
- Author: Philip Hubbard <phubbard@carroll.com>
- Date: Mon, 25 May 1998 19:58:34 -0400
- Well, I can get to the screw in part of the switch from the gear stick apeture but not the other end's connections. I guess I'll try going from underneath the car. There appears to be a hole for some
- /html/spridgets/1998-05/msg00446.html (7,378 bytes)
- 5. Re: Reversing Lamp Switch (score: 1)
- Author: "Steve Byers" <byers@cconnect.net>
- Date: Mon, 25 May 1998 20:23:17 -0400
- The reversing switch takes a 19/32 or 15mm wrench. It's a snug fit with the wrench I have. Just in front of where the screw-in switch is, the two wires should go through a clamp that is attached by
- /html/spridgets/1998-05/msg00447.html (8,451 bytes)
This search system is powered by
Namazu