- 1. Roller rocker and valve cover clearance (score: 1)
- Author: BlueGolfer@aol.com
- Date: Tue, 3 Nov 1998 10:22:41 EST
- Darn, I just had aluminum roller rockers installed on my motor. I now find that they are taller than the stock rockers and interfere with the baffles inside the cast aluminum Sunbeam Tiger Powered by
- /html/tigers/1998-11/msg00040.html (7,168 bytes)
- 2. Re: Roller rocker and valve cover clearance (score: 1)
- Author: Doug Mallory <rdmallory@earthling.net>
- Date: Tue, 3 Nov 1998 12:12:18 -0500
- Grind them out... I have the same setup with no problem. You can run two gaskets glued together but I did not want to take that route. Doug
- /html/tigers/1998-11/msg00043.html (7,575 bytes)
- 3. Re: Roller rocker and valve cover clearance (score: 1)
- Author: Steve Laifman <laifman@flash.net>
- Date: Tue, 03 Nov 1998 09:13:02 -0800
- Presuming you have the "TIGER" valve covers, it can be made to work. You need to cut some round holes, with a very good hole saw, over the push-rod end of the lifter. An end mill would be better. Pr
- /html/tigers/1998-11/msg00044.html (8,200 bytes)
- 4. Re: Roller rocker and valve cover clearance (score: 1)
- Author: "louabbot" <louabbot@mail.ameritel.net>
- Date: Tue, 3 Nov 1998 18:30:23 -0600
- I took the "two gasket" route and it works fine -- together find baffles Has the cover?
- /html/tigers/1998-11/msg00055.html (8,171 bytes)
- 5. Re: Roller rocker and valve cover clearance (score: 1)
- Author: Carmods@aol.com
- Date: Thu, 5 Nov 1998 09:49:19 EST
- Hi Rob, I have run into this problem also. I solved it by cutting out a 3/16 in aluminum spacer the shape of a gasket and by using two gaskets I raised the cover by about 3/8 in. Because there is min
- /html/tigers/1998-11/msg00091.html (7,252 bytes)
This search system is powered by
Namazu