Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Running\s+on\?\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Running\s+on\?\s*$/: 19 ]

Total 19 documents matching your query.

1. Running on? (score: 1): Author: "Scott Gardner" <gardner@lwcomm.com>; Date: Fri, 10 Oct 1997 21:34:13 +0000; Since I've gotten the rebuilt engine back, I've noticed that it will sometimes run on when I turn the key off, and make this wheezing, death-rattle sound as it does. The run-on lasts about three seco; /html/mgs/1997-10/msg00563.html (8,071 bytes)
2. Re: Running on? (score: 1): Author: "Tyson Sherman" <tsherman@tecinfo.com>; Date: Fri, 10 Oct 1997 21:52:18 -0500; My 76 did the same after the engine rebuild. I have never determined the cause of mine, but many say that too-lean of a mixture, too-rich of a mixture, or over-advanced timing are causes. Mine does; /html/mgs/1997-10/msg00567.html (7,969 bytes)
3. Re: Running on? (score: 1): Author: "Vince J. Pujalte" <pujalte@stic.net>; Date: Fri, 10 Oct 1997 22:39:40 -0700; Timing, too-high an idle speed, a portion of the head gasket protruding into the combustion chamber (unlikely) can all contribute to the "dieseling" that you are experiencing. You might try lowering; /html/mgs/1997-10/msg00568.html (8,090 bytes)
4. Re: Running on? (score: 1): Author: "Scott Gardner" <gardner@lwcomm.com>; Date: Fri, 10 Oct 1997 22:28:30 +0000; Thanks for giving me some places to look. Hopefully I'll have the timing spot-on after tomorrow, but the mixture may be a little more hit-and-miss. I leaned the mixture out once already to get rid o; /html/mgs/1997-10/msg00569.html (8,592 bytes)
5. Re: Running on? (score: 1): Author: "Tyson Sherman" <tsherman@tecinfo.com>; Date: Fri, 10 Oct 1997 22:35:49 -0500; I use Bosch Supers (forget the number) gapped to .035" My coil is a cheapo auto zone, as I didn't want to spend $40 ordering one when I didn't know what type to use for ballasted, etc. It works fine; /html/mgs/1997-10/msg00573.html (8,684 bytes)
6. Re: Running on? (score: 1): Author: "Scott Gardner" <gardner@lwcomm.com>; Date: Fri, 10 Oct 1997 22:42:33 +0000; Vince, Thanks for the tip. I lowered the idle speed to about 1000 rpm, which is the lowest it will idle smoothly. I think I need to get the old SUs rebuilt and back on the car. I don't think the 32/; /html/mgs/1997-10/msg00574.html (8,621 bytes)
7. Re: Running on? (score: 1): Author: "Scott Gardner" <gardner@lwcomm.com>; Date: Fri, 10 Oct 1997 22:56:42 +0000; I have the Bosch Platinums now, but will go to the NGKs for consistency's sake. I have the owner's glovebox manual, so will use all of the recommended values as a starting point. I got the Luca spor; /html/mgs/1997-10/msg00576.html (8,959 bytes)
8. Re: Running on? (score: 1): Author: "Scott Gardner" <gardner@lwcomm.com>; Date: Fri, 10 Oct 1997 22:56:42 +0000; Tom, Well, unless I can wrestle my wife's motorcycle away from her, the 'B' is my daily driver, and it's a 35-mile round trip to base. That's pretty much what I expected about the gasoline. Maybe I; /html/mgs/1997-10/msg00577.html (8,399 bytes)
9. Re: Running on? (score: 1): Author: mgb.roadster@juno.com (Larry A Hoy); Date: Fri, 10 Oct 1997 22:07:59 -0600; Scott, I bet your car has to idle at over 1000 rpm with that new cam, right? In order for the car to stop when you shut the key off your car needs to idle at less than 1000 rpm. Ah, but with the new; /html/mgs/1997-10/msg00580.html (9,551 bytes)
10. Re: Running on? (score: 1): Author: "Scott Gardner" <gardner@lwcomm.com>; Date: Sat, 11 Oct 1997 00:09:07 +0000; Larry, If that's the case, I'm in a pickle. Are there other ways to stop the dieseling on a day-to-day basis, like turning on the choke right before I turn the key off, or going to wide-open throttl; /html/mgs/1997-10/msg00581.html (8,052 bytes)
11. Re: Running on? (score: 1): Author: mgb.roadster@juno.com (Larry A Hoy); Date: Fri, 10 Oct 1997 23:27:04 -0600; Scott no real good fix. What I do is set the idle low and setup the choke to move throttle first before it applies choke. When I'm driving around town I pull the choke a bit, when I stop the car I pu; /html/mgs/1997-10/msg00583.html (8,970 bytes)
12. Re: Running on? (score: 1): Author: Art Pfenninger <ch155@FreeNet.Buffalo.EDU>; Date: Sat, 11 Oct 1997 09:08:30 -0400 (EDT); When you say run on do you mean the engine runs normal after you shut it off or do you mean it knocks and chugs before it dies out? ...Art; /html/mgs/1997-10/msg00598.html (9,166 bytes)
13. Re: Running on? (score: 1): Author: Art Pfenninger <ch155@FreeNet.Buffalo.EDU>; Date: Sat, 11 Oct 1997 09:22:10 -0400 (EDT); As far as getting the full benifit from the coil Moss Motoring had an article (I think 2 issues ago) that talked about what had to be done when installing these. It seems that unless done correctly y; /html/mgs/1997-10/msg00599.html (9,907 bytes)
14. Re: Running on? (score: 1): Author: "Scott Gardner" <gardner@lwcomm.com>; Date: Sat, 11 Oct 1997 10:32:34 +0000; Wheezing, rattling, death-rattle sound as is diesels. Normally lasts about three seconds, when it happens. Scott; /html/mgs/1997-10/msg00611.html (8,082 bytes)
15. Re: Running on? (score: 1): Author: Skip Kelsey <kelsey@value.net>; Date: Sat, 11 Oct 1997 08:39:36 -0700; In regards to hooking things up. THe important thing is that the wire from the coil to the distributor be correct. If the car is positie ground, then the wire to the distributor comes from the posit; /html/mgs/1997-10/msg00614.html (10,664 bytes)
16. Re: Running on? (score: 1): Author: "Steve Byers" <byers@cconnect.net>; Date: Sat, 11 Oct 1997 15:14:35 -0400; How 'bout shutting it off in gear and stopping the engine with the clutch? Steve Byers Havelock, NC '73 Midget GAN5UD126009G "OO NINE" '66 BJ8 HBJ8L/36666 "TARHEELY" '63 BJ7 HBJ7L/20111 ("Resting" th; /html/mgs/1997-10/msg00631.html (8,659 bytes)
17. Re: Running on? (score: 1): Author: Art Pfenninger <ch155@FreeNet.Buffalo.EDU>; Date: Sun, 12 Oct 1997 10:26:46 -0400 (EDT); Ok then it's not the problem I had in mind, all the advice that you've gotten should cure the problem or at least help some. It seems like heat and rpm are the biggest factors. ...Art; /html/mgs/1997-10/msg00667.html (7,916 bytes)
18. Re: Running on? (score: 1): Author: mgbob@juno.com (ROBERT G. HOWARD); Date: Mon, 13 Oct 1997 21:06:10 EDT; just leave it in gear when you shut off the ignition, ease out the clutch and stall it. Bob On Sat, 11 Oct 1997 00:09:07 +0000 "Scott Gardner" <gardner@lwcomm.com> writes:; /html/mgs/1997-10/msg00799.html (8,060 bytes)
19. Re: Running on? (score: 1): Author: mgbob@juno.com (ROBERT G. HOWARD); Date: Tue, 14 Oct 1997 07:01:14 EDT; just leave it in gear when you shut off the ignition, ease out the clutch and stall it. Bob On Sat, 11 Oct 1997 00:09:07 +0000 "Scott Gardner" <gardner@lwcomm.com> writes:; /html/mgs/1997-10/msg00825.html (7,952 bytes)

Current List: 1 - 19
Page: [1]