- 1. Re: Rust proofing (score: 1)
- Author: "Paul Hunt" <paul.hunt1@blueyonder.co.uk>
- Date: Sat, 30 Apr 2005 10:56:35 +0100
- If you pour it in it will pour straight out again, unless you block up the drain holes, which is why a long cavity injector spray pipe is usually used. There is usually one hole by the A-post, and if
- /html/mgs/2005-05/msg00039.html (7,191 bytes)
- 2. Rust proofing (score: 1)
- Author: Barrie Robinson <barrie@look.ca>
- Date: Thu, 07 Apr 2005 10:37:02 -0700
- I have used Dinol on the inside of my MGB GT V8 using their spray cans. It's great stuff but I cannot get the loose liquid for the sills and other difficult to-get-into places (unless I buy a 19 litr
- /html/mgs/2005-04/msg00056.html (7,381 bytes)
- 3. Rust proofing (score: 1)
- Author: Barrie Robinson <barrie@look.ca>
- Date: Fri, 29 Apr 2005 16:10:47 -0700
- Thank you all for your responses regarding what to do with rust proofing my sills. I have found a wax based product with inhibitors a la Waxoyl at Cdn$24 (roughly US$19) for 3.78 litres (1 US gallon
- /html/mgs/2005-04/msg00348.html (7,038 bytes)
- 4. Re: Rust proofing (score: 1)
- Author: <ptegler@cablespeed.com>
- Date: Fri, 29 Apr 2005 17:53:58 -0400
- Waxoyl is avail in the U.S. as well. I have a 1 gal squarish container, as well as a round and taller container with it's own supplied sprayer and pump handle right on the can. Yes... sit the contain
- /html/mgs/2005-04/msg00350.html (7,894 bytes)
- 5. Re: Rust proofing (score: 1)
- Author: "Larry Daniels" <ladaniels@sbcglobal.net>
- Date: Fri, 29 Apr 2005 17:42:10 -0500
- I was hoping someone would ask this question, but no luck. Where do you pour the rust inhibitor of choice into the sills? I see a hole in front of the sill plate on each side -- are their other place
- /html/mgs/2005-04/msg00351.html (6,974 bytes)
- 6. Re: Rust proofing (score: 1)
- Author: Barrie Robinson <barrie@look.ca>
- Date: Sat, 30 Apr 2005 09:45:00 -0700
- I have two largish holes and two very small holes on both halves of each sill. They are on top in the door area. I intend to jack one end up and block (duct tape) the lowest holes and fill from high
- /html/mgs/2005-04/msg00362.html (7,907 bytes)
This search system is powered by
Namazu