I pulled my engine on Saturday. It was still running on three cylinders and I took the car on one last drive beforehand. I expect it to be laid up until Summer. Needs a full engine rebuild and a Dats
I just went through this exercise myself. The bolt is 1 5/16ths". The largest half inch drive socket I could find is 1 1/4". Argh. The guy at my local hardware store "rented" me a 3/4" drive socket a
You mean I should have used that key thingy to shut it off? Damn, If I had known that I could have left the engine in there! The Haynes manual recommends that the engine be shut-off before removal :-
There is no mention of that in the Haynes or Bentley manual. Please do your research before answering posts on the list ;) -- Frank Clarici Toms River, NJ Too many Sprites (again) There is a very fin
<< There is no mention of that in the Haynes or Bentley manual. Please do your research before answering posts on the list ;) There IS in "Clymer.........." NAH
Its a little two wheeled vehicle. Mine is chronically underpowered. Good for hill climbing, descending, and transferring large amounts of mud to clothing. They are notoriously hard to start in the m
Feel lucky it's not the 1500. It's a pain to find a 1 13/16 socket at the local store...Thank god I have a friend that works on big trucks...! Dan Dwelley 77 Midget Alexandria, Va. Do You Yahoo!?
Date: Thu, 27 Jan 2000 01:21:20 +0800charset=us-ascii
I had to buy a craftsman, with a 1/2" to 3/4" adapter. Cost around $30 ($22 for socket and 8 for adapter). And then I didn't use it. <grin> But at least I now have it. Mike This message is for the na