- 1. Steering Linkage U-Joint Disassembly (score: 1)
- Author: mbb <2mbb@concentric.net>
- Date: Sun, 16 Apr 2000 17:44:28 -0700
- I'm trying to clean up my steering linkage and would like to take the u-joints apart. I've taken the snap rings out, but everythings still very much together. So now what? How do I take these apart?
- /html/tigers/2000-04/msg00120.html (6,806 bytes)
- 2. Re: Steering Linkage U-Joint Disassembly (score: 1)
- Author: CoolVT@aol.com
- Date: Sun, 16 Apr 2000 22:23:58 EDT
- Mark, I set mine up in vice. Using old sockets, use one the same diameter as the pin as a pusher and one on the other side as a receiver. The receiver socket should be large enough internally for the
- /html/tigers/2000-04/msg00122.html (7,005 bytes)
- 3. Re: Steering Linkage U-Joint Disassembly (score: 1)
- Author: Mark & Carla Meswarb <mmeswarb@itexas.net>
- Date: Sun, 16 Apr 2000 21:37:55 -0500
- Note: You need to completely remove the bolt that runs next to the spline or the u-joint won't slide off the shaft. Mark
- /html/tigers/2000-04/msg00124.html (7,277 bytes)
- 4. Re: Steering Linkage U-Joint Disassembly (score: 1)
- Author: Larry Paulick <larry.p@erols.com>
- Date: Mon, 17 Apr 2000 10:03:51 -0400
- Mark, I assume that you have the u-joints out of the car, and if so you can use a socket and a large vise to press the u-joint as far as it will go to one side, take off the cap and the needle bearin
- /html/tigers/2000-04/msg00129.html (7,185 bytes)
This search system is powered by
Namazu