Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR\-6\s+Throttle\s+Linkage\s+Bushings\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR\-6\s+Throttle\s+Linkage\s+Bushings\s*$/: 3 ]

Total 3 documents matching your query.

1. TR-6 Throttle Linkage Bushings (score: 1): Author: Jack Wheeler <jwheeler@robus.com>; Date: Wed, 1 Sep 1999 07:03:49 -0500; -- =_NextPart_000_01BEF448.24A88880 I purchased a set of supposedly stock plastic accelerator shaft bushings for a TR-6 I am working on. These are the bushings that support the shaft where it goes th; /html/fot/1999-09/msg00000.html (8,757 bytes)
2. Re: TR-6 Throttle Linkage Bushings (score: 1): Author: cak@dimebank.com (Chris Kantarjiev); Date: Wed, 1 Sep 1999 07:14:22 -0700; Heat is your friend. Boil them in water for 15 minutes (don't let the pot boil dry!) and they will be much easier to install (but very hot so use gloves).; /html/fot/1999-09/msg00002.html (6,618 bytes)
3. Re: TR-6 Throttle Linkage Bushings (score: 1): Author: Bob Lang <LANG@isis.mit.edu>; Date: Wed, 01 Sep 1999 10:22:45 -0400 (EDT); This is probably "Triumph sacrilige", but I've had success by cutting the bushing at one point (radially) with a utility knife, then soaking in hot water and then pushing them in with a rubber mallet; /html/fot/1999-09/msg00003.html (8,222 bytes)

Current List: 1 - 3
Page: [1]