Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR3\s+leaky\s+rear\s+end\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR3\s+leaky\s+rear\s+end\s*$/: 6 ]

Total 6 documents matching your query.

1. TR3 leaky rear end (score: 1): Author: mrv8q@netscape.net; Date: Wed, 27 Apr 2005 22:58:55 -0400; Hello, listers, I replaced the differential cover gasket on my TR3 when I first got it, because there was a fair amount of leakage. I must have done a poor job, because it's worse than before. Aftr s; /html/triumphs/2005-04/msg00809.html (7,532 bytes)
2. RE: TR3 leaky rear end (score: 1): Author: "Randall" <tr3driver@comcast.net>; Date: Wed, 27 Apr 2005 21:47:10 -0700; Are you certain the cover/housing gasket is where it's leaking ? My experience has been that they're pretty easy to seal. But, if the front seal is leaking, or you've got a tube loose in the pumpkin; /html/triumphs/2005-04/msg00812.html (7,684 bytes)
3. Re: TR3 leaky rear end (score: 1): Author: Dave1massey@cs.com; Date: Thu, 28 Apr 2005 07:58:40 EDT; My experience with RTV gasket sealers is that they are finicky and do not seal to surfaces that have even a slight hint of oil. I much prefer Form-A-Gasket #2 for this application. It is much more to; /html/triumphs/2005-04/msg00815.html (7,527 bytes)
4. Re: TR3 leaky rear end (score: 1): Author: Kurtis Jones <tr4driver@gmail.com>; Date: Thu, 28 Apr 2005 07:33:46 -0500; I agree with Randall. I first suspected the gasket on my leaky differential (perhaps because that's the easiest leak to address). However, after replacing the gasket, I noticed no decrease in puddle; /html/triumphs/2005-04/msg00818.html (8,344 bytes)
5. RE: TR3 leaky rear end (score: 1): Author: "Randall" <tr3driver@comcast.net>; Date: Thu, 28 Apr 2005 07:38:30 -0700; That's usually a result of not letting them set up properly before assembling. If you apply it to one surface, like the cover, and then wait at least 15 minutes before assembling, it will seal bette; /html/triumphs/2005-04/msg00819.html (7,380 bytes)
6. Re: TR3 leaky rear end (score: 1): Author: Dave1massey@cs.com; Date: Thu, 28 Apr 2005 13:02:52 EDT; Another technique that may not work in all situations is to assemble the parts just shy of tight and let cure. Then the tightening process will put the silicone under compression and it is more likel; /html/triumphs/2005-04/msg00823.html (7,355 bytes)

Current List: 1 - 6
Page: [1]