Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR3a\s+windscream\s+assembly\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR3a\s+windscream\s+assembly\s*$/: 6 ]

Total 6 documents matching your query.

1. TR3a windscream assembly (score: 1): Author: Unknown; Date: Thu, 18 Mar 1999 13:55:09 -0500; I've just put new glass in the frame, and as usual it didn't go without a hitch. The glazing rubber or whatever it's called that I got from Moss was way too thick, so I took it to the local auto glas; /html/triumphs/1999-03/msg01193.html (7,714 bytes)
2. Re: TR3a windscream assembly (score: 1): Author: Unknown; Date: Thu, 18 Mar 1999 11:19:59 -0800 "TR3a windscream assembly" (Mar 18, 1:55pm); I don't know if this is the problem or not but there's definitly a front side and a back side to the lower seal. In fact the stuff from one of the suppliers (TRF I think) has the word REAR embossed; /html/triumphs/1999-03/msg01198.html (9,786 bytes)
3. RE: TR3a windscream assembly (score: 1): Author: Unknown; Date: Thu, 18 Mar 1999 11:30:01 -0800; I've tried it both ways. If you put it in just tight enough so the edge lays down on the scuttle (some waves off the car, but not much), then eventually it will shrink and tear at the ends. Seems to; /html/triumphs/1999-03/msg01200.html (9,203 bytes)
4. RE: TR3a windscream assembly (score: 1): Author: Unknown; Date: Thu, 18 Mar 1999 14:25:35 -0500charset="iso-8859-1"; Jim - Did the same thing. (stretched it) Ended up with a 2" wide bulge that stood up about 1/2" right in front of the grip bar on passenger side. Put mild heat on it; tried everything I could but it; /html/triumphs/1999-03/msg01201.html (9,383 bytes)
5. Re: TR3a windscream assembly (score: 1): Author: Unknown; Date: Thu, 18 Mar 1999 20:12:36 EST; << So here's the question: once this rubber is installed, should it be kind of wavy, to accomodate the bend it will undergo when placed against the body? Or, have I stretched it too much? Or, will it; /html/triumphs/1999-03/msg01222.html (7,592 bytes)
6. Re: TR3a windscream assembly (score: 1): Author: Unknown; Date: Fri, 19 Mar 1999 09:41:28 -0800 "RE: Re: TR3a windscream assembly" (Mar 19, 12:31pm); Fred Thomas (aka vafred) pointed out that my graphic may not be very clear. The seal want to point straight down or a little to the back of the windshield BEFORE the w/s is placed on the car. The se; /html/triumphs/1999-03/msg01280.html (10,404 bytes)

Current List: 1 - 6
Page: [1]