Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR6\s+Gas\s+Pump\s+Valves\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR6\s+Gas\s+Pump\s+Valves\s*$/: 5 ]

Total 5 documents matching your query.

1. TR6 Gas Pump Valves (score: 1): Author: Unknown; Date: Sun, 09 Nov 1997 21:27:51 -0800; Looking for some advice on rebuilding the gas pump on my '70 TR6. I purchased a rebuild kit from Moss (TRF did not have them in stock), removed the pump from the engine block. After cleaning the cove; /html/triumphs/1997-11/msg00639.html (7,725 bytes)
2. RE: TR6 Gas Pump Valves (score: 1): Author: Unknown; Date: Mon, 10 Nov 97 03:23:30 UT; Looking for some advice on rebuilding the gas pump on my '70 TR6. I purchased a rebuild kit from Moss (TRF did not have them in stock), removed the pump from the engine block. After cleaning the cove; /html/triumphs/1997-11/msg00651.html (8,644 bytes)
3. Re: TR6 Gas Pump Valves (score: 1): Author: Unknown; Date: Mon, 10 Nov 1997 09:11:02 -0800; When I did mine I found the metal was peened over the valves and I too had a devil of a job getting the old ones out. To get the new ones in, I put the pump body in the oven at 200 degrees, this expa; /html/triumphs/1997-11/msg00667.html (9,746 bytes)
4. RE: TR6 Gas Pump Valves (score: 1): Author: Unknown; Date: Mon, 10 Nov 1997 10:51:17 -0700; Scott, I used a short piece of copper tubing. I don't recall the dimensions but if you take the pump and valves to a plumbing/hardware store you should be able to match it up. I think 1/2" OD was the; /html/triumphs/1997-11/msg00685.html (9,021 bytes)
5. Re: TR6 Gas Pump Valves (score: 1): Author: Unknown; Date: Mon, 10 Nov 1997 20:15:25 -0800; Craig: The kit I got was also an AC Delco kit. Plan on measuring tonight. I didn't notice any indentations, but wasn't looking for any either. Did you use a Dremel (sp?) to grind the inside of the ho; /html/triumphs/1997-11/msg00715.html (8,742 bytes)

Current List: 1 - 5
Page: [1]